A Comparison of Fracture Limit Analysis on Titanium Grade 2 and Titanium Grade 4 Sheets During Single Point Incremental Forming
- 4 September 2019
- journal article
- research article
- Published by Springer Nature in Journal of Failure Analysis and Prevention
- Vol. 19 (5) , 1286-1296
Abstract
No abstract availableKeywords
This publication has 35 references indexed in Scilit:
- Microstructural investigation and lubrication study for single point incremental forming of copperInternational Journal of Solids and Structures, 2018
- Damage prediction in single point incremental forming using an extended Gurson modelInternational Journal of Solids and Structures, 2018
- Heat-assisted incremental sheet forming: a state-of-the-art reviewThe International Journal of Advanced Manufacturing Technology, 2018
- Characterizing fracture forming limit and shear fracture forming limit for sheet metalsJournal of Materials Processing Technology, 2018
- Anisotropic effects in the compression beading of aluminum thin-walled tubes with rubberThin-Walled Structures, 2017
- Numerical prediction of the ductile damage in single point incremental forming processInternational Journal of Mechanical Sciences, 2017
- Numerical prediction of springback and ductile damage in rubber-pad forming process of aluminum sheet metalInternational Journal of Mechanical Sciences, 2016
- Review on the influence of process parameters in incremental sheet formingThe International Journal of Advanced Manufacturing Technology, 2016
- Formability of lightweight alloys by hot incremental sheet formingMaterials & Design (1980-2015), 2012
- Research and Progress in Incremental Sheet Forming ProcessesMaterials and Manufacturing Processes, 2011