Effect of Arc Current Ultrasonic-Frequency Pulsation on Plasma Cut Quality
Authors:
- 1 August 2009
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 628-629, 721-726
Abstract
The present work proposes a novel plasma cutting system using the ultrasonic frequency pulsed arc, and then experimentally investigates the effect of pulse process parameters on cut quality in the frequencies of 20-60 kHz. It is shown that kerf widths, bevel angle, straightness and dross attached level decrease obviously with the appropriate increases in the frequency and amplitude of pulse current. Furthermore, cutting heat affected zone narrows and cut hardness drops clearly in the pulsed cutting. This current pulsation can thus improve plasma cut quality remarkably, and finally leads to a narrower, flatter and more perpendicular cut of better remachinability. Experimental results simultaneously demonstrate that the effectiveness of the ultrasonic-frequency pulsed cutting process developed at the low current of arc.Keywords
This publication has 5 references indexed in Scilit:
- Grain refinement and high performance of titanium alloy joint using arc-ultrasonic gas tungsten arc weldingScience and Technology of Welding and Joining, 2006
- Analysis of electrical characteristics for hybrid pulsed micro-tungsten inert gas welding arcScience and Technology of Welding and Joining, 2004
- Investigation into micro-tungsten inert gas arc behaviour and weld formationScience and Technology of Welding and Joining, 2004
- A Study on the Cut Surface Quality of Mild Steel Plate by Oxygen Plasma Arc Cutting.QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 1999
- Zeros of functions in weighted Bergman spaces.The Michigan Mathematical Journal, 1977