Effect of vital bleaching on surface roughness and microhardness of nanofilled and nanohybrid composite resins
Open Access
- 2 February 2023
- journal article
- research article
- Published by F1000 Research Ltd in F1000Research
- Vol. 12, 129
Abstract
Background: To compare the surface roughness and microhardness of Ceram.x® SphereTEC™ one and Filtek Z350 XT after in-office vital bleaching with Pola office. Methods: A total of 20 samples of 10 mm diameter and 2 mm height of Ceram.x® SphereTEC™ one and Filtek Z350 XT were prepared. The samples were subjected to two bleaching sessions with 35% hydrogen peroxide (Pola office) with a seven-day interval between each session. Surface roughness and microhardness of the prepared samples prior to and after the bleaching regimen were measured using a profilometer and Vickers hardness tester, respectively. Results: A significant reduction (p <0.001) in the surface hardness of Filtek Z350 XT from 26.67 ± 2.10 to 17.83 ± 1.36 Vickers hardness number (VHN) was observed after the bleaching whereas no significant reduction in surface hardness was observed with Ceram.x® SphereTEC™ one. However, in-office bleaching of these materials did not significantly alter their surface roughness. Conclusions: The effect of in-office bleaching on the surface hardness of resin composites seem to vary due to variations in the composition of dental composites such as filler loading. Among the composites tested, in office bleaching of Ceram.x® SphereTEC™ did not result in significant changes in its surface hardness and roughness.Keywords
This publication has 19 references indexed in Scilit:
- An overview of vital teeth bleachingJournal of Interdisciplinary Dentistry, 2016
- Evaluation of surface roughness of different restorative composites after polishing using atomic force microscopyJournal of Conservative Dentistry, 2016
- In Situ Surface Biodegradation of Restorative MaterialsOperative Dentistry, 2014
- Effect of in-office bleaching agents on physical properties of dental composite resins2013
- Investigation of the correlation between the different mechanical properties of resin compositesDental Materials Journal, 2013
- The effects of temperature and bleaching gels on the properties of tooth-colored restorative materialsThe Journal of Prosthetic Dentistry, 2011
- Effect of In-Office Bleaching on Color and Surface Roughness of Composite RestorativesEuropean Journal of Dentistry, 2010
- Effect of tooth-bleaching methods on gloss and color of resin compositesJournal of Dentistry, 2010
- Effect of Bleaching on Color Change and Refractive Index of Dental Composite ResinsDental Materials Journal, 2008
- Higher‐Concentration Carbamide Peroxide Effects on Surface Roughness of CompositesJournal of Esthetic and Restorative Dentistry, 2002