Formation of Mg–Cu–Ni–Ag–Zn–Y–Gd Bulk Glassy Alloy by Casting into Cone-shaped Copper Mold in Air Atmosphere
- 1 June 2005
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 20 (6) , 1465-1469
Abstract
A new Mg–Cu–Ni–Ag–Zn–Y–Gd alloy with significantly improved glass forming ability (GFA) was developed in this work. Mg65Cu7.5Ni7.5Ag5Zn5Y5Gd5 bulk metallic glass (BMG) with a diameter of 14 mm was successfully fabricated by conventional copper mold casting method in air atmosphere. The critical cooling rate for glass formation was estimated to be about 20 K/s. When the maximum diameter for glass formation was compared with those previously reported for Mg-based alloys, the Mg65Cu7.5Ni7.5Ag5Zn5Y5Gd5 alloy showed the highest GFA. However, when the GFA was compared with those of Mg-TM-RE alloys (TM: Cu, Ni, Zn, and Ag; RE: Y and Gd), the significant improved GFA of the Mg–Cu–Ni–Zn–Ag–Y–Gd alloy cannot be properly represented by ΔTx, Trg, K, and γ parameters. In contrast to most of the Mg-based BMGs reported so far, the Mg65Cu7.5Ni7.5Ag5Zn5Y5Gd5 BMG exhibits yielding and plastic deformation during compressive loading.Keywords
This publication has 25 references indexed in Scilit:
- Bulk glass formation in the Ni–Zr–Ti–Nb–Si–Sn alloy systemJournal of Materials Research, 2004
- Formation of Ca–Mg–Zn bulk glassy alloy by casting into cone-shaped copper moldJournal of Materials Research, 2004
- Bulk Glass Formation in Mg-Cu-Ag-Y-Gd AlloyMATERIALS TRANSACTIONS, 2004
- A new Mg65Cu7.5Ni7.5Zn5Ag5Y10 bulk metallic glass with strong glass-forming abilityJournal of Materials Research, 2003
- Fabrication and Mechanical Properties of Mg65Cu15Ag5Pd5Gd10 Bulk Metallic GlassMATERIALS TRANSACTIONS, 2003
- A new glass-forming ability criterion for bulk metallic glassesActa Materialia, 2002
- Bulk metallic glass formation in the Mg–Cu–Zn–Y systemScripta Materialia, 2002
- Enhanced plastic strain in Zr-based bulk amorphous alloysPhysical Review B, 2001
- Preparation of Bulk Glassy Mg65Y10Cu15Ag5Pd5 Alloy of 12 mm in Diameter by Water QuenchingMATERIALS TRANSACTIONS, 2001
- Evaluation of glass-forming tendency by means of DTACzechoslovak Journal of Physics, 1972