Phase Inversion in Polylactide/Soybean Oil Blends Compatibilized by Poly(isoprene-b-lactide) Block Copolymers
- 2 October 2009
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 1 (10) , 2390-2399
Abstract
Renewable composites were prepared by melt blending of polylactide and soybean oil. The blend morphology was tuned by the addition of poly(isoprene-b-lactide) block copolymers. Due to the extreme difference in the viscosities of soybean oil and polylactide, a critical block copolymer composition was found to induce a phase inversion point at which the minor soybean oil phase became the matrix surrounding polylactide particles. This transition was due to the thermodynamic interactions between the block copolymer and the two phases and shear forces acting on the mixture during blending. The size of the soybean oil droplets in the polylactide matrix was also highly dependent on the block copolymer composition. In binary polylactide/soybean oil blends, there was a limiting concentration of soybean oil that could be incorporated into the polylactide matrix (6% of the total blend weight), which could be increased up to 20% by the addition of block copolymers.Keywords
This publication has 50 references indexed in Scilit:
- Sustainability of Biobased and Biodegradable PlasticsCLEAN – Soil, Air, Water, 2008
- Toughening PolylactidePolymer Reviews, 2008
- Toughening of Polylactide by Melt Blending with a Biodegradable Poly(ether)urethane ElastomerMacromolecular Bioscience, 2007
- Polymer blends and composites from renewable resourcesProgress in Polymer Science, 2006
- The influence of block copolymer microstructure on the toughness of compatibilized polylactide/polyethylene blendsPolymer, 2004
- Biodegradable plastics from renewable sourcesFolia Microbiologica, 2003
- Properties of lactic acid based polymers and their correlation with compositionProgress in Polymer Science, 2002
- Sustainable Bio-Composites from Renewable Resources: Opportunities and Challenges in the Green Materials WorldJournal of Polymers and the Environment, 2002
- A Literature Review of Poly(Lactic Acid)Journal of Polymers and the Environment, 2001
- Hydrolytic degradation characteristics of aliphatic polyesters derived from lactic and glycolic acidsJournal of Biomedical Materials Research, 1999