Sequence stratigraphic-based analysis of reservoir connectivity: influence of depositional architecture – a case study from a marginal marine depositional setting
- 1 August 2005
- journal article
- Published by Geological Society of London in Petroleum Geoscience
- Vol. 11 (3) , 257-276
Abstract
This case study of the Sunrise and Troubadour fields (offshore northwest Australia) concentrates on the impact of primary depositional architecture on reservoir connectivity via a sequence stratigraphic-based, 3D reservoir modelling approach. The marginal marine reservoir is composed of fluvial-dominated and wave-dominated depositional environments. The succession is divided into six sequences and 12 systems tracts. Each systems tract is subdivided into parasequences which form the basic building blocks of the 3D model. The connectivity of sandbodies within each parasequence, systems tract and sequence were calculated when the models were palinspastically restored to a depositional datum. The findings indicate that depositional connectivity trends within a sequence stratigraphic framework are predictable. Connectivity trends can be related directly to depositional and stratigraphic trends and to position in the sequence stratigraphic hierarchy. Therefore, with a good understanding of depositional settings and high resolution sequence stratigraphic subdivision of strata, predictions of depositional connectivity trends at all stratigraphic hierarchical levels can be made. All connectivity trends at sequence and systems tract stratigraphic hierarchical levels remained the same when the area of the model was reduced by a factor of four and the volume of the model was reduced by truncation below the gas–water contact. Hence, the relationships between the stratigraphic trends and the connectivity trends for the thicker stratigraphic units can be said to be scale invariant. Three-dimensional reservoir models currently provide the best means of quantitatively assessing and predicting reservoir connectivity. However, in low fault density settings, initial screening of reservoir connectivity can be made using connectivity indicators calculated from simple parameters derived from well data such as ‘Thickness divided by Sand/Shale ratio’.Keywords
This publication has 27 references indexed in Scilit:
- The effect of faults on the 3D connectivity of reservoir bodies: a case study from the East Pennine Coalfield, UKPetroleum Geoscience, 2002
- The falling stage systems tract: recognition and importance in sequence stratigraphic analysisGeological Society, London, Special Publications, 2000
- Aspects of the stratal architecture of forced regressive depositsGeological Society, London, Special Publications, 2000
- Assessment of the effects of sub-seismic faults on bulk permeabilities of reservoir sequencesGeological Society, London, Special Publications, 1998
- Modelling of sandbody connectivity in the Schooner FieldGeological Society, London, Special Publications, 1997
- 3D Modeling To Optimize Production at the Successive Stages of Field LifeSPE Formation Evaluation, 1996
- The application of physical measurements to constrain reservoir-scale sequence stratigraphic modelsGeological Society, London, Special Publications, 1996
- Which sub-seismic heterogeneities influence waterflood performance? A case study of a low net-to-gross fluvial reservoirGeological Society, London, Special Publications, 1995
- The Connectivity and Conductivity of Overlapping Sand Bodies1990
- A Review of Stochastic Models for Petroleum Reservoirs1989