Effect of cutting parameters on surface quality in ductile cutting of KDP crystal using self-developed micro PCD ball end mill
Authors:
- 6 December 2014
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 78 (1-4) , 221-229
Abstract
No abstract availableKeywords
This publication has 20 references indexed in Scilit:
- Research on full-aperture ductile cutting of KDP crystals using spiral turning techniqueJournal of Materials Processing Technology, 2013
- EFFECT OF CRYSTALLOGRAPHIC ORIENTATION ON CUTTING FORCES AND SURFACE FINISH IN DUCTILE CUTTING OF KDP CRYSTALSMachining Science and Technology, 2011
- Design and development of PCD micro straight edge end mills for micro/nano machining of hard and brittle materialsJournal of Mechanical Science and Technology, 2010
- Critical Undeformed Chip Thickness and Cutting Pressure in Relation to Ductile Mode Cutting of KDP CrystalKey Engineering Materials, 2010
- Investigation of anisotropic mechanisms in ultra-precision diamond machining of KDP crystalJournal of Materials Processing Technology, 2009
- Analysis of 3D microtopography in machined KDP crystal surfaces based on fractal and wavelet methodsInternational Journal of Machine Tools and Manufacture, 2008
- Effects of the Tool Angles on the Machined Surface Quality of KDP Crystal in Diamond TurningKey Engineering Materials, 2007
- Analysis of Mechanical Property of Crystal KDP and Simulation of Ultra-Precision Cutting Process in the Ductile ModeKey Engineering Materials, 2007
- A Static Model of Chip Formation in Microscale MillingJournal of Manufacturing Science and Engineering, 2004
- The Mechanics of Machining at the Microscale: Assessment of the Current State of the ScienceJournal of Manufacturing Science and Engineering, 2004