3D printing parameters of acrylonitrile butadiene styrene polymer for friction and wear analysis using response surface methodology
- 16 May 2020
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 235 (2) , 468-477
Abstract
This study intends to analyse the coefficient of friction and wear properties of the acrylonitrile butadiene styrene polymer by determining the optimal parameters for 3D printing. The pin specimens were produced using the fused filament fabrication 3D printing. Response surface methodology is used for the multivariate analysis, and Box–Behnken Design is the chosen symmetrical design method. Changes to the dependent variables, coefficient of friction and wear rate, were analysed as a function of the nozzle temperature, layer height and printing pattern. The coefficient of friction and wear rate were measured using a pin-on-disc tribometer. A good agreement between the modelled and measured values of coefficient of friction and wear rate was observed. The study suggests that layer height affecting coefficient of friction and wear rate most significantly. It is determined that a layer height of 0.10 mm and a nozzle temperature of 234℃ using the triangle printing pattern is the optimal set of combination to minimise coefficient of friction and wear rate.Keywords
This publication has 12 references indexed in Scilit:
- Comparative study of the tribological behaviour of 3D-printed and moulded ABS under lubricated conditionMaterials Research Express, 2019
- A critical review of fused deposition modeling 3D printing technology in manufacturing polylactic acid partsThe International Journal of Advanced Manufacturing Technology, 2019
- Application of Taguchi Method in Investigating The Effect of Layer Thickness and Fill Angle on FDM PartsIOP Conference Series: Materials Science and Engineering, 2018
- An Overview on Additive Manufacturing of PolymersJOM, 2018
- Comparison of wear behavior of ABS and ABS composite parts fabricated via fused deposition modellingInternational Journal of ADVANCED AND APPLIED SCIENCES, 2018
- Influence of Layer Thickness and Raster Angle on the Mechanical Properties of 3D-Printed PEEK and a Comparative Mechanical Study between PEEK and ABSMaterials, 2015
- Connection between dynamic mechanical properties and sliding wear resistance of polymersMaterials Research Innovations, 2006
- Critical parameters influencing the quality of prototypes in fused deposition modellingJournal of Materials Processing Technology, 2001
- An overview of the use of generalized linear models in response surface methodologyNonlinear Analysis, 2001
- On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviourWear, 2000