High-Cycle Fatigue Behavior of Bimetallic Bearing Shell Plates
Open Access
Abstract
Sliding bearing shells experience repeated bending loads, and fatigue cracking of the copper-alloy working layer can limit their service life. This study evaluated the high-cycle fatigue behavior of steel-backed copper-alloy plates using reciprocating bending tests and finite element fatigue analysis. Specimens were tested at displacement amplitudes of 1.25, 1.50, 2.00, and 2.50 mm under fully reversed loading, with a run-out limit of 10 million cycles. No macroscopic cracks were observed at amplitudes of 1.25–2.00 mm after 10 million cycles; at 2.50 mm, a visible crack appeared at approximately 8.2 million cycles. As displacement amplitude increased from 1.25 to 2.50 mm, the simulated maximum stress rose from 322.31 to 644.62 MPa, while the minimum fatigue safety factor fell from 3.1676 to 0.79191. At 2.50 mm, the predicted high-stress and low-safety-factor regions corresponded spatially to the experimentally observed cracking region. Fracture-surface observations indicated that cracking began at the copper-alloy surface, advanced toward the copper–steel interface, and was followed by cracking in the steel backing near the interface. These findings identify a critical displacement-amplitude range of 2.00–2.50 mm for the tested configuration and show how combined fatigue testing and simulation can help locate fatigue-critical regions in bimetallic bearing plates.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (3132026512)
This publication has 24 references indexed in Scilit:
- Simultaneously enhancing mechanical and bonding property of Cu-Ni-Si/1010 steel bimetal laminated composites via annealingMaterials Characterization, 2025
- Damage mechanics coupled with a transfer learning approach for the fatigue life prediction of bronze/steel diffusion welded bimetallic materialInternational Journal of Fatigue, 2024
- A review of bearing failure Modes, mechanisms and causesEngineering Failure Analysis, 2023
- Evolution of interface and mechanical performance of Cu-xAl/1010 steel bimetal laminated compositeJournal of Alloys and Compounds, 2022
- Microstructure and properties of copper-steel bimetallic sheets prepared by friction stir additive manufacturingJournal of Manufacturing Processes, 2022
- Microstructural characteristics and mechanical properties of bronze/steel bimetallic laminated composite prepared by protective atmosphere casting processChina Foundry, 2021
- Simulation and experimental verification of fatigue strength evaluation of journal bearing bushEngineering Failure Analysis, 2020
- Experimental and numerical investigations of interface characteristics of copper/steel composite prepared by explosive weldingMaterials & Design, 2018
- Failure mechanisms in motor bearingsEngineering Failure Analysis, 2005
- Tensile surface stresses and fatigue in plain journal bearingsTribology International, 1992