Thickness change and springback of cold roll bonded aluminum/copper clad sheets in air bending process
- 8 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 231 (4) , 675-689
Abstract
In this article, an advanced analytical formulation is developed to predict thickness change of an aluminum/copper clad sheet. Springback analytical formulation is also introduced using the combination of advanced and primary bending theories in air bending process. Experiments were performed to verify analytical results and to investigate the effect of different geometrical parameters such as punch stroke, die opening, punch radius and setting condition on the springback. It was observed that die opening had the most striking effect, while setting condition had a negligible effect on springback. On the other hand, setting condition played a crucial role on thickness change in bent clad sheets. Clad sheet thickened in the Al/Cu setting condition, while in the Cu/Al setting it thinned. Finite element method simulation was also applied to verify analytical predictions of the thickness change and study stress distribution in the layers of the clad sheet. Good correlation was observed between analytical and numerical results.Keywords
This publication has 29 references indexed in Scilit:
- Fabrication and anti-oxidation properties of Al/Ti-6Al-4V bimetallic clad-sheet by multi-pass friction stir weldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2014
- A novel approach to diffusion bonding of copper to stainless steelProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2011
- Effects of processing parameters on the bond strength of Cu/Cu roll-bonded stripsJournal of Materials Processing Technology, 2010
- Tool shape design in the sheet bending process by inverse analysis of springbackProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- A study of joint quality of aluminum and low carbon steel strips by warm rollingMaterials & Design (1980-2015), 2009
- A new approach for inverse analysis of springback in a sheet-bending processProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2008
- Investigation of different parameters on roll bonding quality of aluminium and steel sheetsInternational Journal of Material Forming, 2008
- A study of warm and cold roll-bonding of an aluminium alloyMaterials Science and Engineering: A, 2004
- Cold roll bonding of 5754-aluminum stripsMaterials Science and Engineering: A, 2002
- Bond Strength in Cold Roll BondingCIRP Annals, 1985