Evaluation of hydraulic, pneumatic and mechanical agitation for the spray application ofSteinernema carpocapsae(Rhabditida: Steinernematidae)
Authors:
- 22 January 2010
- journal article
- research article
- Published by Taylor & Francis in Biocontrol Science and Technology
- Vol. 20 (4) , 339-351
Abstract
The application of entomopathogenic nematodes (EPN) is generally done using standard spray application techniques. However, in contrast to chemical pesticides, these biological antagonists must remain viable during and after the application process. For the application of EPN, a good agitation system is indispensable as the nematodes tend to sediment fast in a spray tank without agitation. Three agitation systems, viz. mechanical, pneumatic and hydraulic agitation were tested for their ability to keep Steinernema carpocapsae (Rhabditida: Steinernematidae) suspended in an undamaged way. Hydraulic agitation was tested using a centrifugal and a diaphragm pump. Nematode damage was quantified based on viability and infectivity of the EPN. The ability of the agitation system to keep the nematodes in suspension was examined by comparing the nematode concentration observed in the samples taken at different agitation times. Only the hydraulic agitation using the centrifugal pump damaged the nematodes. After 120 min of recirculation, only 19.3% of the nematodes survived. Infectivity was even reduced to 0%. An additional experiment revealed that the temperature rise, from 21.7 to 45.4°C, was responsible for the observed nematode damage. The concentration measurements showed that the pneumatic agitation was unstable. Agitation during 120 min using the other agitation systems resulted in a significant loss of nematodes at 15 cm above the spray tank bottom. In conclusion, mechanical and hydraulic agitation using a diaphragm pump can be recommended when S. carpocapsae is applied, although attention should be paid to possible nematode loss during application.Keywords
This publication has 11 references indexed in Scilit:
- The effect of agitation system, temperature of the spray liquid, nematode concentration, and air injection on the viability ofHeterorhabditis bacteriophoraBiocontrol Science and Technology, 2007
- Application technology and environmental considerations for use of entomopathogenic nematodes in biological controlBiological Control, 2006
- Mode of action of a surfactant–polymer formulation to support performance of the entomopathogenic nematodeSteinernema carpocapsaefor control of diamondback moth larvae (Plutella xylostella)Biocontrol Science and Technology, 2005
- VIABILITY OF A BIOLOGICAL PEST CONTROL AGENT THROUGH HYDRAULIC NOZZLESTransactions of the ASAE, 2005
- Biology and behaviour.2005
- Evaluation of a contraction flow field on hydrodynamic damage to entomopathogenic nematodes—A biological pest control agentBiotechnology and Bioengineering, 2004
- Effects of pressure differentials on the viability and infectivity of entomopathogenic nematodesBiological Control, 2003
- Genetic Variability in Stress Tolerance and Fitness among Natural Populations of Steinernema carpocapsaeBiological Control, 2002
- Influence of application technique on the viability of the biological control agents Verticillium lecanii and Steinernema feltiaeCrop Protection, 1999
- Physical properties of liquid nematode cultures and the design of recovery operationsBioprocess and Biosystems Engineering, 1998