Modeling capability of R134a for a critical heat flux of water in a vertical 5×5 rod bundle geometry
Authors:
- 30 April 2006
- journal article
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 49 (7-8) , 1299-1309
Abstract
No abstract availableKeywords
This publication has 15 references indexed in Scilit:
- Comparison of the CHF data for water and refrigerant HFC-134a by using the fluid-to-fluid modeling methodsInternational Journal of Heat and Mass Transfer, 2007
- An experimental study on the critical heat flux for low flow of water in a non-uniformly heated vertical rod bundle over a wide range of pressure conditionsNuclear Engineering and Design, 2005
- CHF characteristics of R-134a flowing upward in uniformly heated vertical tubeInternational Journal of Heat and Mass Transfer, 2005
- Comparison of CHF measurements in R-134a cooled tubes and the water CHF look-up tableInternational Journal of Heat and Mass Transfer, 2001
- Some problems for bundle CHF prediction based on CHF measurements in simple flow geometriesNuclear Engineering and Design, 2000
- An improved physical model for flooding limited CHF under zero and very low flow conditionsInternational Communications in Heat and Mass Transfer, 1998
- Limitations of the fluid-to-fluid scaling technique for critical heat flux in flow boilingInternational Journal of Heat and Mass Transfer, 1995
- PREDICTION OF CRITICAL HEAT FLUX (CHF) FOR HON-AQUEOUS FLUIDS IN FORCED CONVECTIVE BOILING1986
- A generalized correlation of critical heat flux for the forced convection boiling in vertical uniformly heated round tubesInternational Journal of Heat and Mass Transfer, 1978
- Fluid to fluid modeling of critical heat flux: A compensated distortion modelInternational Journal of Heat and Mass Transfer, 1973