A sustainable alternative for cooling the machining processes using a refrigerant fluid in recirculation inside the toolholder
- 9 March 2011
- journal article
- Published by Springer Nature in Clean Technologies and Environmental Policy
- Vol. 13 (6) , 831-840
Abstract
No abstract availableKeywords
This publication has 21 references indexed in Scilit:
- Investigation of tool wear and cutting force in cryogenic machining using design of experimentsJournal of Materials Processing Technology, 2008
- Improving tool life using cryogenic coolingJournal of Materials Processing Technology, 2008
- Friction and cutting forces in cryogenic machining of Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2001
- The influence of cryogenic cooling on tool wear, dimensional accuracy and surface finish in turning AISI 1040 and E4340C steelsWear, 2001
- Cooling approaches and cutting temperatures in cryogenic machining of Ti-6Al-4VInternational Journal of Machine Tools and Manufacture, 2001
- Economical and ecological cryogenic machining of AISI 304 austenitic stainless steelClean Technologies and Environmental Policy, 2000
- Improving low carbon steel chip breakability by cryogenic chip coolingInternational Journal of Machine Tools and Manufacture, 1999
- Dry CuttingCIRP Annals, 1997
- Study of the jet-flow rate of cooling in machining Part 2. Simulation studyJournal of Materials Processing Technology, 1996
- Study of the jet-flow rate of cooling in machining Part 1. Theoretical analysisJournal of Materials Processing Technology, 1996