Design of Three-dimensional Isotropic Microprobe Based on Three-Flexible-Hinge Suspension for Measurement of Microstructures
- 6 May 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 25 (4) , 2123-2133
Abstract
To enhance the precision manufacturing of microstructures, a three-dimensional (3D) isotropic microprobe based on three-flexible-hinge suspension and orthogonal microball collimation was developed. First, the sensing principle of the microprobe was investigated by analyzing its displacement transfer principle and the displacement measurement principle of the orthogonal microball collimation optical paths. Second, the stiffness model of the microprobe at the tip was established by considering the influence of the measuring stylus stiffness. Subsequently, the isotropic design of the microprobe was developed in terms of the 3D isotropic stiffness and sensitivity. Utilizing the rotation and translation of the three-flexible-hinge suspension, the 3D tip displacements were transformed into the 3D displacements of the microball of the transfer stylus which was fixed in the reverse coaxial direction to the measuring stylus, then the 3D displacements of the microball were transformed into centroid position shifts of the light spots by the orthogonal microball collimation optical paths. Finally, a 3D isotropic microprobe was fabricated, and experiments to verify its performance for measurements pertaining to microholes and microsteps were conducted. A method for the effective measurement of microholes was established, which could improve the measurement efficiency, and the tilt angle of the countertop was considered for the measurement of the microsteps. The experimental results indicated that the proposed microprobe could help realize low measurement force, 3D isotropic measurement of microstructures, and improvement of the measurement accuracy.Keywords
Funding Information
- National Natural Science Foundation of China (51575140)
This publication has 13 references indexed in Scilit:
- Fabrication of a Smart Suspension Structure of Micro Tactile ProbingProcedia Engineering, 2014
- Fiber probe for micro-hole measurement based on detection of returning light energySensors and Actuators A: Physical, 2013
- Tactile 3D microprobe system with exchangeable styliMeasurement Science and Technology, 2011
- Novel design for an ultra high precision 3D micro probe for CMM applicationsProcedia Engineering, 2010
- New concept of a 3D-probing system for micro-componentsCIRP Annals, 2010
- Ultraprecision micro-CMM using a low force 3D touch probeMeasurement Science and Technology, 2007
- A silicon-etched probe for 3-D coordinate measurements with an uncertainty below 0.1 μmIEEE Transactions on Instrumentation and Measurement, 2001
- Micromechanical three-axial tactile force sensor for micromaterial characterisationMicrosystem Technologies, 2001
- Design for a Compact High-Accuracy CMMCIRP Annals, 1999
- Development of a fast mechanical probe for coordinate measuring machinesPrecision Engineering, 1998