Optimizing plant density to improve the soil microenvironment and enhance crop productivity in cotton/cumin intercropping systems
Authors:
Open Access
- 10 February 2025
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Plant Science
- Vol. 16, 1533211
Abstract
Introduction: Residual film pollution has become a key factor that affects the sustainable development of cotton, and intercropping may be an economical and environmentally friendly method to reduce the negative effects of nonmulched conditions on cotton growth. We hypothesized that optimizing the cotton/cumin intercropping density would improve the soil environment and increase crop productivity and resource utilization.Methods: Therefore, in this study, singlecropping cotton (CK) was used as the control, and three intercropping cumin seeding densities were used (plants ha-1: 5×105, ID1; 8×105, ID2; and 11×105, ID3). Through a two-year field experiment, the effects of cotton-cumin intercropping on the soil moisture, temperature, salt, respiration rate, weed density, cotton yield formation and intercropping advantages were studied.Results and discussion: Compared with the CK treatment, the ID2 treatment decreased the water content in the 0–30 cm soil layer by 8.3%, increased the water consumption by 9.1%, increased the soil temperature by 0.5°C, and decreased the electrical conductivity of the 0–15 cm soil layer by 17.7%. Compared with the CK treatment, the ID1 treatment significantly decreased the soil respiration rate by 33.6%, and the weed density decreased in the following order: CK>ID1>ID2>ID3. During the nonsymbiotic period, compared with CK, ID2 increased the soil water content by 5.7%, increased the soil respiration rate by 17.7%, and decreased the electrical conductivity by 15.6%. Compared with those for CK and ID3, the seed yield for ID2 increased by 2.0% and 5.8%, respectively, and that for ID1 decreased by 1.6%. However, the land equivalent of the ID2 treatment was 4.3% greater than that for the ID1 treatment. Therefore, intercropping cumin at a density of 8×105 plants ha-1 is beneficial for increasing surface coverage, significantly increasing crop water consumption, increasing surface temperature, reducing soil electrical conductivity and carbon emissions, and improving the crop yield and economic benefits. This model can be used as an agroecologically friendly and sustainable planting model.Keywords
This publication has 48 references indexed in Scilit:
- Integrated effects of plastic film residues on cotton growth and field carbon sequestration under drip irrigation in arid oasis regionsAgriculture, Ecosystems & Environment, 2022
- Water and heat resource utilization of cotton under different cropping patterns and their effects on crop biomass and yield formationAgricultural and Forest Meteorology, 2022
- Effect of Tillage Implements and Weed Management Techniques On Nutritive Values of Wheat GrainsGesunde Pflanzen, 2021
- Influence of jujube/cotton intercropping on soil temperature and crop evapotranspiration in an arid areaAgricultural Water Management, 2021
- A meta-analysis on cover crop impact on soil water storage, succeeding crop yield, and water-use efficiencyAgricultural Water Management, 2021
- Water utilization in intercropping: A reviewAgricultural Water Management, 2020
- Cotton/mung bean intercropping improves crop productivity, water use efficiency, nitrogen uptake, and economic benefits in the arid area of Northwest ChinaAgricultural Water Management, 2020
- Intercropping Optimizes Soil Temperature and Increases Crop Water Productivity and Radiation Use Efficiency of Rainfed PotatoAmerican Journal of Potato Research, 2019
- Rainfall partitioning into throughfall, stemflow and interception loss by maize canopy on the semi-arid Loess Plateau of ChinaAgricultural Water Management, 2018
- Long-term record and analysis of soil temperatures and soil heat fluxes in a grassland area, The NetherlandsAgricultural and Forest Meteorology, 2011