On the testability of IEEE 1687 networks
- 1 November 2015
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 211-216
Abstract
Due to the increasing usage of embedded instruments in many electronic devices, new solutions to effectively access these instruments appeared, including the new IEEE 1687 standard. The approach supported by IEEE 1687 allows a flexible access to embedded instruments through the Boundary Scan interface. The IEEE 1687 network includes a set of reconfigurable scan chains. This paper addresses the issue of testing the circuitry implementing them, checking whether any permanent hardware fault exists, affecting either the registers associated to the instruments made accessible by the network, or the configuration structures it embeds (e.g., the multiplexers and the associated flip-flops). The paper proposes an approach, in which the IEEE 1687 network undergoes a sequence of test sessions, each composed of a configuration phase and a test phase. By properly selecting the network configurations to be used, we can guarantee that the method can test any permanent fault possibly affecting the network. We also provide some experimental results gathered on a set of benchmark networks, allowing to practically evaluate the viability of the approach.Keywords
This publication has 9 references indexed in Scilit:
- Design and validation of a novel reconfigurable and defect tolerant JTAG scan chain2014
- Test Scheduling in an IEEE P1687 Environment with Resource and Power Constraints2011
- Access Time Analysis for IEEE P1687IEEE Transactions on Computers, 2011
- Design automation for IEEE P16872011
- On the Detectability of Scan Chain Internal Faults An Industrial Case Study26th IEEE VLSI Test Symposium (vts 2008), 2008
- A set of benchmarks for modular testing of SOCs2003
- An optimal test sequence for the JTAG/IEEE P1149.1 test access port controller2003
- On the testing of multiplexers2003
- A universal test sequence for CMOS scan registers2002