Submodeling Analysis for Path-Dependent Thermomechanical Problems
Authors:
- 28 September 2004
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 127 (2) , 135-140
Abstract
In a finite element analysis, when localized behavior of a large model is of particular concern, generally one would refine the mesh until it captures the local solution adequately. Submodeling is an alternative way for solving this kind of problem. It provides a relatively accurate solution at a modest computational cost. For a valid submodeling analysis, the boundaries of the submodel should be sufficiently far away from local features so that St. Venant’s principle holds. Moreover, special treatments are required for solving problems that involve path-dependent characteristics. This paper presents a general procedure to perform submodeling analyses for path-dependent thermomechanical problems without a priori assumptions on the structural response. The procedure was benchmarked using a bimaterial strip and demonstrated through analyses on a bump chip carrier package assembly. The procedure is conducive to the numerical assessment of fatigue lives of electronic packages.Keywords
This publication has 8 references indexed in Scilit:
- Verification of submodeling technique in thermomechanical reliability assessment of flip-chip package assemblyMicroelectronics Reliability, 2005
- Reliability Modeling for Ball Grid Array Assembly With a Large Number of Warpage Affected Solder JointsJournal of Electronic Packaging, 2002
- Effect of Simulation Methodology on Solder Joint Crack Growth Correlation and Fatigue Life PredictionJournal of Electronic Packaging, 2002
- A Full-Scale 3D Finite Element Analysis for No-Underfill Flip Chip Package2002
- Interfacial Delamination Near Solder Bumps and UBM in Flip-Chip PackagesJournal of Electronic Packaging, 2000
- Rate dependent constitutive relations based on Anand model for 92.5Pb5Sn2.5Ag solderIEEE Transactions on Advanced Packaging, 2000
- Plasticity and CreepJournal of Applied Mechanics, 1994
- Finite element analysis for Solder Ball Connect (SBC) structural design optimizationIBM Journal of Research and Development, 1993