Study of the solid state joining of additive manufactured components
- 1 September 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
The additive manufacturing technologies are finding an increasing use due to their peculiarities. A limit that still hampers their massive application is the maximum dimension of the components than can be produced. This paper deals with the study of the joining process of additive manufactured parts. In particular, two different cases have been studied: i) Ti6Al4V parts made through electron beam melting joined through linear friction welding; ii) AlSi10Mg parts made through direct metal laser sintering joined through friction stir welding. The results obtained showed the feasibility of both the processes.Keywords
This publication has 4 references indexed in Scilit:
- Comparison of the microstructures and mechanical properties of Ti–6Al–4V fabricated by selective laser melting and electron beam meltingMaterials & Design, 2016
- A Review of Additive ManufacturingISRN Mechanical Engineering, 2012
- Evaluation of Titanium Alloys Fabricated Using Rapid Prototyping Technologies—Electron Beam Melting and Laser Beam MeltingMaterials, 2011
- Consolidation phenomena in laser and powder-bed based layered manufacturingCIRP Annals, 2007