Polymerization Stress Development in Dental Composites: Effect of Cavity Design Factor
Open Access
Abstract
The objective of the study was to assess the effect of the cavity design factor (C-factor) on polymerization stress development (PSD) in resin composites. An experimental resin (BT resin) was prepared, which contained 2,2-bis[p-(2’-hydroxy-3’-methacryloxypropoxy)phenylene]propane (B) and triethylene glycol dimethacrylate (T) in 1:1 mass ratio, and an activator for visible light polymerization. An experimental composite with demonstrated remineralizing potential was also formulated by inclusion into the BT resin of zirconia-hybridized amorphous calcium phosphate (ACP) filler at a mass fraction of 40 % (BT/ACP composite). A commercial glass-filled composite (TPH) was used as a control. To assess the effect of the test geometry on PSD, C-factor was systematically varied between 0.8 and 6.0 by varying the height of the cylindrical composite specimens. The measured PSD values obtained by cantilever beam tensometry for specimens with variable C-factors were normalized for mass to specimens with a C-factor of 1.33 (h=2.25 mm) as controls to give calculated PSD values. Degrees of vinyl conversions (DC) attained in the TPH control and in the experimental BT/ACP composites were measured by near-infrared spectroscopy. In both the TPH and BT/ACP composite series, PSDcalc increased with the increasing C-factor, confirming the hypothesis that the C-factor value influences PSD values. The higher PSDmeas and PSDcalc values for the experimental BT/ACP composite compared to the commercial TPH composite probably reflect differences in the type and mass of the resin and filler phases in the two types of composite. These differences also account for the observed variation (21 %) in DC attained in a BT/ACP composite 2 h after cure (69.5 %) and in the DC of the TPH composite (57.5 %) having the same C-factor. The cavity design factor seems to play a key role in influencing the PSD of bonded composites, but other factors such as composite mass and composition also must be considered for their effects on PSD.Keywords
This publication has 35 references indexed in Scilit:
- Axial shrinkage-stress depends upon both C-factor and composite massDental Materials, 2008
- Influence of instrument compliance and specimen thickness on the polymerization shrinkage stress measurement of light-cured compositesDental Materials, 2007
- Dental Composites Based on Amorphous Calcium Phosphate — Resin Composition/Physicochemical Properties StudyJournal of Biomaterials Applications, 2007
- Developing a more complete understanding of stresses produced in dental composites during polymerizationDental Materials, 2005
- Contraction Stress Related to Degree of Conversion and Reaction KineticsJournal of Dental Research, 2002
- The Influence of Configuration Factors on Cavity Adaptation in Compomer Restorations.Dental Materials Journal, 1999
- Quantitative determination of stress reduction by flow in composite restorationsDental Materials, 1990
- Wall‐to‐wall polymerization contraction of composite resins versus filler contentEuropean Journal of Oral Sciences, 1987
- Setting Stress in Composite Resin in Relation to Configuration of the RestorationJournal of Dental Research, 1987
- The Relationship Between Test Methodology and Elastic Behavior of CompositesJournal of Dental Research, 1987