A Wall-Mounted Robot Arm Equipped With a 4-DOF Yaw-Pitch-Yaw-Pitch Counterbalance Mechanism
- 21 February 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics and Automation Letters
- Vol. 5 (3) , 3768-3774
Abstract
Because industrial robots are relatively heavy, most of motor torque are used to support the weight of a robot. Consequently, high-capacity motors and speed reducers are needed, resulting in a low energy efficiency and an increase in the manufacturing cost. To deal with this problem, a variety of spring-based counterbalance mechanisms (CBM) have been developed to mechanically compensate for the gravitational torque caused by the robot weight and payload. However, conventional CBMs are limited to pitch joints whose axis of rotation is parallel to the ground and it is difficult to apply them to robot arms with different joint configurations, such as humanoid robot arms. In this study, we propose a CBM with a passive yaw-pitch structure consisting of a spring and wire. Through geometrical analysis and experiments, we demonstrate that the proposed CBM can effectively compensate for the gravitational torque due to robot weight and payload.Keywords
Funding Information
- Ministry of Trade, Industry and Energy
- Industrial Foundation Technology Development
- Korea Evaluation Institute of Industrial Technology (20005032)
This publication has 11 references indexed in Scilit:
- Design of a 6-DOF collaborative robot arm with counterbalance mechanisms2017
- Multiple-Degree-of-Freedom Counterbalance Robot Arm Based on Slider-Crank Mechanism and Bevel Gear UnitsIEEE Transactions on Robotics, 2015
- Gravity compensation in roboticsAdvanced Robotics, 2015
- Multi-DOF Counterbalance Mechanism for a Service Robot ArmIEEE/ASME Transactions on Mechatronics, 2014
- Design of a Static Balancing Mechanism for a Serial Manipulator With an Unconstrained Joint Space Using One-DOF Gravity CompensatorsIEEE Transactions on Robotics, 2013
- Static balancing of a manipulator with hemispherical work space2010
- A novel mechanism design for gravity compensation in three dimensional space2004
- A new parallelogram linkage configuration for gravity compensation using torsional springs2003
- Passive mechanical gravity compensation for robot manipulators2002
- Effect of mass balancing on the actuator torques of a manipulatorMechanism and Machine Theory, 1995