A simulation analysis of photovoltaic AC Module Integrated Converters in parallel, under controlled edge shading conditions
Authors:
- 1 May 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 699-705
Abstract
A DC and AC power simulation comparison of: a Photovoltaic (PV) array with a modular, parallel, AC converter configuration; and a series, string configuration with a central AC converter, is presented. The systems are simulated using a comprehensive range of edge shading scenarios and irradiance conditions. Power control and transformation circuitry must be designed for shade and module mismatch tolerance to prevent over-proportional power to shade losses, as average losses from Building Integrated PV (BIPV) systems are approximately 20 to 25%, due to shade, mismatch, differences in orientation and inclination, and temperature effects. 59.4% of the simulations showed gains in AC power by using the parallel modular converter system, with a maximum gain of 10.74%, when compared with the series configuration. Losses up to 6.61% can be experienced when most of the modules are experiencing edge shading of 200 or 400W/m2, as i) the converter efficiency is lower in this power range for the modular converter, and ii) this low efficiency conversion occurs n times, where n is the number of modules in the array. Significant power increases are experienced by the parallel modular system when there is a wide distribution of irradiance levels within the shading pattern.Keywords
This publication has 12 references indexed in Scilit:
- Forecasting photovoltaic array power production subject to mismatch lossesSolar Energy, 2010
- High-efficiency grid-connected photovoltaic module integrated converter system with high-speed communication interfaces for small-scale distribution power generationSolar Energy, 2010
- Analysis Model of Mismatch Power Losses in PV SystemsJournal of Solar Energy Engineering, 2009
- PV inverter test setup for European efficiency, static and dynamic MPPT efficiency evaluation2008
- MATLAB-Based Modeling to Study the Effects of Partial Shading on PV Array CharacteristicsIEEE Transactions on Energy Conversion, 2008
- Topology Study of Photovoltaic Interface for Maximum Power Point TrackingIEEE Industrial Electronics Magazine, 2007
- Flyback-Type Single-Phase Utility Interactive Inverter With Power Pulsation Decoupling on the DC Input for an AC Photovoltaic Module SystemIEEE Transactions on Power Electronics, 2006
- Intelligent PV Module for Grid-Connected PV SystemsIEEE Transactions on Industrial Electronics, 2006
- Measurements, analyses and evaluation of residential PV systems by Japanese monitoring programSolar Energy Materials and Solar Cells, 2003
- Low cost DC to AC converter for photovoltaic power conversion in residential applications1993