Effects of Rotational Speed and Processing Time on Bonding Strength of Porous Aluminum and Thermoplastic Resin during Friction Welding
Authors:
- 1 May 2022
- journal article
- research article
- Published by Japan Institute of Metals in Journal of the Japan Institute of Metals and Materials
- Vol. 86 (5) , 71-76
Abstract
In this study, the bonding of porous aluminum (porous Al) and thermoplastic acrylic resin by friction welding was attempted. We investigated the relationship between bonding conditions (rotational speed of porous aluminum and processing time during friction welding) and the bonding strength during friction welding. This method enables us to obtain porous Al composite materials by bonding with anchor effects relatively easily in a short processing time. Therefore, it is expected to be applied to the fabrication of industrial products. Porous Al with a porosity of approximately 70% was fabricated by the spacer method, and then it was welded to an acrylic resin plate by friction welding. A tensile test was conducted on a bonded specimen to investigate the bonding strength. At a rotational speed of 680 rpm, a specimen with the maximum bonding strength was obtained at the processing time of 60 s. However, in case of longer processing time the bonding strength decreased with increasing processing time. At a rotational speed of 1100 rpm, a specimen with the maximum bonding strength was obtained at the processing time of 40 s, which the bonding strength decreased with increasing processing time. At a rotational speed of 2000 rpm, a specimen with the maximum bonding strength was obtained at the processing time of 20 s, which the bonding strength decreased with increasing processing time. The decrease in bonding strength was considered to be caused by the generation of acrylic resin gas due to excessive frictional heat and a decrease in the thickness of the acrylic resin. It was concluded that porous Al and acrylic resin can be successfully bonded by friction welding, and that the higher the rotational speed, the shorter the processing time required for bonding.Keywords
This publication has 11 references indexed in Scilit:
- Friction welding of porous aluminum and polycarbonate plateMaterials Letters, 2021
- Plastic joining of open-cell nickel foam and polymethyl methacrylate (PMMA) sheet by friction stir incremental formingJournal of Materials Processing Technology, 2020
- Influence of corrosion on the mechanical properties of hybrid sandwich structures with CFRP face sheets and aluminum foam coreComposite Structures, 2018
- Effect of layer thickness on bonding strength of Al/epoxy resin joints via interpenetrating phase layerJournal of Materials Processing Technology, 2018
- Sandwich Structures Consisting of Aluminum Foam Core and Fiber Reinforced Plastic Top LayersAdvanced Engineering Materials, 2017
- Commercial Applications of Metal Foams: Their Properties and ProductionMaterials, 2016
- Advances in friction welding process: A reviewScience and Technology of Welding and Joining, 2010
- Aluminium foams for lighter vehiclesInternational Journal of Vehicle Design, 2005
- Fabrication of Porous Aluminum by Spacer Method Consisting of Spark Plasma Sintering and Sodium Chloride DissolutionMATERIALS TRANSACTIONS, 2005
- A novel sintering-dissolution process for manufacturing Al foamsScripta Materialia, 2001