Plastic-containing materials as alternative reductants for base metal production
Open Access
- 14 November 2018
- journal article
- research article
- Published by Taylor & Francis in Canadian Metallurgical Quarterly
- Vol. 58 (2) , 164-176
Abstract
Shredder residue materials are produced after the removal of ferrous and non-ferrous fractions from end-of-life electronic equipment. Despite the high plastic content and metal value in the ash, high percentages of these materials are currently sent to landfills. In this study, the potential of utilising shredder residue material and other plastic-containing materials as reducing agents was studied. Plastic-containing materials were co-injected with coal into a zinc-fuming furnace in Boliden-Rönnskär smelter. The data obtained from the trial, such as the data from the chemical analysis of the slag and the steam production, are discussed. The observations indicate that plastic-containing material can replace up to 1 ton h−1 of coal without a significant decrease in the zinc reduction rate.Keywords
Funding Information
- VINNOVA
- Stena International Recycling
- Kuusakoski Sverige AB
- CAMM
- Lulea University of Technology
This publication has 10 references indexed in Scilit:
- Alternative Reducing Agents in Metallurgical Processes: Devolatilization of Shredder Residue MaterialsJournal of Sustainable Metallurgy, 2016
- Influence of alumina on physical properties of an industrial zinc-copper smelting slagPart 1 – viscosityMineral Processing and Extractive Metallurgy: Transactions of the Institutions of Mining and Metallurgy: Section C, 2013
- Computational Fluid Dynamics (CFD) Investigation of Submerged Combustion Behavior in a Tuyere Blown Slag-fuming FurnaceMetallurgical and Materials Transactions B, 2012
- Recycling Plastics as a Resource for Electric Arc Furnace (EAF) Steelmaking: Combustion and Structural Transformations of Metallurgical Coke and Plastic BlendsEnergy & Fuels, 2010
- Thermal valorisation of automobile shredder residue: injection in blast furnaceWaste Management, 2002
- The Effect of Injection Parameters on Slag FumingCanadian Metallurgical Quarterly, 1995
- Heat-transfer phenomena in water-cooled zinc-fuming furnace jacketsMetallurgical Transactions B, 1991
- High-pressure coal injection in zinc slag fumingMetallurgical Transactions B, 1989
- Mathematical Model of Lead Behaviour in the Zinc Slag Fuming ProcessCanadian Metallurgical Quarterly, 1988
- Fuming of Zinc from Lead Blast Furnace SlagJOM, 1955