Numerical Simulation for the Influence of EMS Position on Fluid Flow and Inclusion Removal in a Slab Continuous Casting Mold
Authors:
- 15 June 2020
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 60 (6) , 1204-1212
Abstract
Electromagnetic stirring (EMS) has been used to improve the steel quality in continuous casting process and EMS position is a key factor in optimizing the stirring performance. In order to clarify the issue that where to install the electromagnetic stirrer, a mathematical model, coupling electromagnetic field and fluid flow field, was developed in this paper. Three cases differing in EMS position have been investigated: the stirrer was installed above the submerged entry nozzle (SEN) port; the stirrer was installed near it; and the stirrer was installed below it. The model was validated by the comparison of electromagnetic flux density. The influence of EMS position on electromagnetic force, flow field and inclusion removal was analyzed. Index Rc was introduced to quantify the possibility of slag entrapment. The results shows that as the stirrer moves downwards, the maximum electromagnetic force increases, index Rc increases first and then turns to decrease, and the electromagnetic force causes the jet to bend more horizontally, resulting in an inactive zone when the stirrer is installed near the SEN port. Furthermore, under our computed condition, to improve the inclusion removal, the stirrer is suggested to be installed below the SEN port.Keywords
This publication has 46 references indexed in Scilit:
- Optimisation of Electromagnetic Stirring in Steel Billet Caster by Using Image Processing Technique for Improvement in Billet QualityISIJ International, 2009
- Effect of Properties of Mold Powder Entrapped into Molten Steel in a Continuous Casting ProcessISIJ International, 2009
- Molten Steel Flow Control under Electromagnetic Level Accelerator in Continuous Casting MoldISIJ International, 2007
- Mathematical Modeling of Iron and Steel Making Processes. Mathematical Modeling of Fluid Flow in Continuous Casting.ISIJ International, 2001
- Fluid Flow in a Continuous Casting Mold Driven by Linear Induction Motors.ISIJ International, 2001
- In-mold electromagnetic stirring in continuous castingIEEE Transactions on Industry Applications, 2001
- Model Study on the Entrapment of Mold Powder into Molten Steel.ISIJ International, 2000
- Magnetohydrodynamic calculation of in-mold electromagnetic stirringIEEE Transactions on Magnetics, 1997
- Electromagnets applied to thin steel plateIEEE Transactions on Magnetics, 1996
- Mathematical Modelling of Transport Phenomena in Continuous Casting of Steel.ISIJ International, 1994