Friction factors in pulsed turbulent flow
Authors:
- 1 April 1971
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 49 (2) , 220-223
Abstract
An apparatus for investigating pulsed turbulent liquid flow in a 2 in. diameter, 80 ft. pipeline is described. The pulsation unit was powered by compressed air with a consumption of up to 2.7 std. cu.ft./min. at 35 lb/in2 gauge. The pressure drop for water flowing at mean velocities of 7.66 to 12.28 ft./sec. has been measured, both for steady flow and for pulsed flow, at frequencies between 0.48 and 0.82 Hz. The experimentally measured pressure versus time curves for pulsed flow can be matched fairly closely by a solution of Euler's equation employing the friction factors measured under steady flow conditions.Keywords
This publication has 8 references indexed in Scilit:
- Small-Amplitude Frequency Behavior of Fluid Lines With Turbulent FlowJournal of Basic Engineering, 1969
- Power consumption and gas hold-up in a pulsed columnChemical Engineering Science, 1967
- Hydraulic Transients Caused by Reciprocating PumpsJournal of Engineering for Power, 1967
- Friction factors and pressure drop for sinusoidal laminar flow of water and blood in rigid tubesAIChE Journal, 1967
- Similarity Laws for Localized ScourJournal of the Hydraulics Division, 1966
- Wärmeübergang bei pulsierender StrömungChemie Ingenieur Technik, 1958
- Method for the calculation of velocity, rate of flow and viscous drag in arteries when the pressure gradient is knownThe Journal of Physiology, 1955
- Pulsierender Durchflu\ durch RohreForschung im Ingenieurwesen, 1940