Durability of Pt-Co Alloy Polymer Electrolyte Fuel Cell Cathode Catalysts under Accelerated Stress Tests
Open Access
- 16 March 2018
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 165 (6) , F3166-F3177
Abstract
The durability of Pt-Co alloy cathode catalysts supported on high surface area carbon is investigated by subjecting them to accelerated stress tests (ASTs). The catalysts had different initial Co contents and nanoparticle morphologies: a “spongy” porous morphology for the high-Co (H) content catalyst, and a fully alloyed crystalline morphology for the medium-Co (M) and low-Co (L) content catalysts. The specific activity of the catalysts depends on their initial Co content, morphology and nanoparticle size, and remained higher than 1000 μA/cm2-Pt after 27–50% Co loss. The H-catalyst electrode showed the smallest kinetic overpotentials (ηcs) due to higher initial Pt loading than the other two electrodes, but it had the fastest increase in ηcs with AST cycling due to lower Co retention; the L-catalyst electrode showed higher ηcs due to a lower initial Pt loading, but had a smaller increase in ηcs with aging due to higher Co retention; the M-catalyst electrode showed a similar increase in ηcs with aging, but this increase was due to the combined effects of Co dissolution and electrochemically active surface area (ECSA) loss. The modeled increase in mass transfer overpotentials with aging correlates with the initial Pt loading, ECSA loss and the initial catalyst morphology.Keywords
Funding Information
- USDOE/EERE/FCTO
This publication has 30 references indexed in Scilit:
- Analysis of proton exchange membrane fuel cell catalyst layers for reduction of platinum loading at NissanElectrochimica Acta, 2011
- In situ metal ion contamination and the effects on proton exchange membrane fuel cell performanceJournal of Power Sources, 2011
- Durability of Pt[sub 3]Co/C Cathodes in a 16 Cell PEMFC Stack: Macro/Microstructural Changes and Degradation MechanismsJournal of the Electrochemical Society, 2010
- Platinum-Alloy Cathode Catalyst Degradation in Proton Exchange Membrane Fuel Cells: Nanometer-Scale Compositional and Morphological ChangesJournal of the Electrochemical Society, 2010
- Identification and Quantification of Oxygen Species Adsorbed on Pt(111) Single-Crystal and Polycrystalline Pt Electrodes by Photoelectron SpectroscopyLangmuir, 2009
- Cathode Catalyst Utilization for the ORR in a PEMFCJournal of the Electrochemical Society, 2007
- Determination of O and OH Adsorption Sites and Coverage in Situ on Pt Electrodes from Pt L23 X-ray Absorption SpectroscopyThe Journal of Physical Chemistry B, 2005
- Surface-oxide growth at platinum electrodes in aqueous H2SO4*1Reexamination of its mechanism through combined cyclic-voltammetry, electrochemical quartz-crystal nanobalance, and Auger electron spectroscopy measurementsElectrochimica Acta, 2004
- Kinetic Analysis of Oxygen Reduction on Pt(111) in Acid Solutions: Intrinsic Kinetic Parameters and Anion Adsorption EffectsThe Journal of Physical Chemistry B, 2004
- Polymer Electrolyte Fuel Cell ModelJournal of the Electrochemical Society, 1991