The results are presented of an investigation to evaluate the behavior of commercial stainless steels, superalloys, and aluminide coatings in both clean (sulfur-free) and raw (1% H/sub 2/S) gas representative of the Texaco slagging gasifier atmosphere at 1400 to 1800/sup 0/F (1033 to 1255/sup 0/K). The goal was to determine which, if any, of these materials is suitable for use in a high temperature heat exchanger operating on intermediate Btu coal gasification atmospheres. It has been found that none of the commercially available alloys or coatings are suitable for use in the raw (1% H/sub 2/S) gas, even at temperatures as low as 1400/sup 0/F (1033/sup 0/K). Materials that are resistant to attack either have a limited life (< 5000 h) or cannot be fabricated as large size heat exchanger components. It is concluded that structural high temperature alloys must be coated for use in the raw gas and that the best coating or cladding materials are Ni-46Cr (IN671 type alloy) and MCrAl with 25 to 40% Cr and 30 to 40% Al (where M is Ni, Co, or Fe or some combination thereof). Heat exchanger components can be clad with Ni-46Cr but the alloy must be modified to improvemore » its reliability and performance in coal conversion atmospheres. The MCrAl coatings have excellent resistance to sulfidation but processes to deposit the coatings on large components must be developed. Ebrite 26-1 and Type 310 stainless have excellent resistance to attack by the clean gas and the latter alloy is recommended as the best material for heat exchanger components that will be coated on the raw gas side. Significant advances in coating technology are required before serious consideration can be given to design of large coated heat exchangers. Recommendations for advancing technology with both types of coating systems are presented. « less