In Situ treatment of PFAS‐impacted groundwater using colloidal activated Carbon
Author:
- 6 June 2018
- journal article
- research article
- Published by Wiley in Remediation Journal
- Vol. 28 (3) , 33-41
Abstract
Poly‐ and perfluoroalkyl substances (PFASs) have been identified by many regulatory agencies as contaminants of concern within the environment. In recent years, regulatory authorities have established a number of health‐based regulatory and evaluation criteria with groundwater PFAS concentrations typically being less than 50 nanograms per liter (ng/L). Subsurface studies suggest that PFAS compounds are recalcitrant and widespread in the environment. Traditionally, impacted groundwater is extracted and treated on the surface using media such as activated carbon and exchange resins. These treatment technologies are generally expensive, inefficient, and can take decades to reach treatment objectives. The application of in situ remedial technologies is common for a wide variety of contaminants of concern such as petroleum hydrocarbons and volatile organic compounds; however, for PFASs, the technology is currently emerging. This study involved the application of colloidal activated carbon at a site in Canada where the PFASs perfluorooctanoate (PFOA) and perfluorooctane sulfonic acid (PFOS) were detected in groundwater at concentrations up to 3,260 ng/L and 1,450 ng/L, respectively. The shallow silty‐sand aquifer was anaerobic with an average linear groundwater velocity of approximately 2.6 meters per day. The colloidal activated carbon was applied using direct‐push technology and PFOA and PFOS concentrations below 30 ng/L were subsequently measured in groundwater samples over an 18‐month period. With the exception of perfluoroundecanoic acid, which was detected at 20 ng/L and perfluorooctanesulfonate which was detected at 40 ng/L after 18 months, all PFASs were below their respective method detection limits in all postinjection samples. Colloidal activated carbon was successfully distributed within the target zone of the impacted aquifer with the activated carbon being measured in cores up to 5 meters from the injection point. This case study suggests that colloidal activated carbon can be successfully applied to address low to moderate concentrations of PFASs within similar shallow anaerobic aquifers.Keywords
This publication has 18 references indexed in Scilit:
- Sorbent amendment as a remediation strategy to reduce PFAS mobility and leaching in a contaminated sandy soil from a Norwegian firefighting training facilityChemosphere, 2017
- Degradation and Removal Methods for Perfluoroalkyl and Polyfluoroalkyl Substances in WaterEnvironmental Engineering Science, 2016
- Occurrence of select perfluoroalkyl substances at U.S. Air Force aqueous film-forming foam release sites other than fire-training areas: Field-validation of critical fate and transport propertiesChemosphere, 2016
- Removal of perfluorooctane sulfonate (PFOS) and perfluorooctanoate (PFOA) from water by coagulation: Mechanisms and influencing factorsJournal of Colloid and Interface Science, 2014
- Evidence of Remediation-Induced Alteration of Subsurface Poly- and Perfluoroalkyl Substance Distribution at a Former Firefighter Training AreaEnvironmental Science & Technology, 2014
- Behavior and Fate of PFOA and PFOS in Sandy Aquifer SedimentGroundwater Monitoring & Remediation, 2012
- Bioremediation of Petroleum oil Contaminated Soil and WaterResearch Journal of Environmental Toxicology, 2011
- Levels and trends of poly- and perfluorinated compounds in the arctic environmentScience of The Total Environment, 2010
- Defluorination of Organofluorine Sulfur Compounds by Pseudomonas Sp. Strain D2Environmental Science & Technology, 1998
- A slug test for determining hydraulic conductivity of unconfined aquifers with completely or partially penetrating wellsWater Resources Research, 1976