Electrostatic Rotary Stepper Micromotor for Skew Angle Compensation in Hard Disk Drive
Authors:
- 1 January 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1079-1082
Abstract
Circular data tracks in present-day hard disk drives (HDD) are accessed by a read/write head mounted on a support arm, which is swung by a voice coil drive. The orientation of the head relative to a data track varies with the radial position of the track, causing an increase in data track misregistration and limiting the performance of HDD. We present a rotary micromotor which can be used as a secondary stage actuator to maintain a constant orientation between the head and the tracks during disk operation. This electrostatic stepper micromotor, bulk micromachined in a standard monocrystalline silicon wafer, uses flexure pivots to avoid any frictional contact of the rotor, providing precise, repeatable and reliable bidirectional stepping motion without feedback control. The experimental characterization of a prototype having a diameter of 1.4 mm has demonstrated a rotational range of 26deg (+/- 13deg) at 75 V, a resolution of 1/6deg in a coarse stepping mode and a maximum speed of 1.67deg/ms.Keywords
This publication has 7 references indexed in Scilit:
- Versatile trench isolation technology for the fabrication of microactuatorsMicroelectronic Engineering, 2003
- Embedded interconnect and electrical isolation for high-aspect-ratio, SOI inertial instruments2002
- Optimization of a magnetic disk drive actuator with small skew actuationJournal of Applied Physics, 2002
- Design and fabrication of an angular microactuator for magnetic disk drivesJournal of Microelectromechanical Systems, 1998
- Magnetic recording-head positioning at very high track densities using a microactuator-based, two-stage servo systemIEEE Transactions on Industrial Electronics, 1995
- Surface micromachined mechanisms and micromotorsJournal of Micromechanics and Microengineering, 1991
- IC-processed electrostatic micromotorsSensors and Actuators, 1989