Tailored for simplicity: creating high porosity, high performance bio-based macroporous polymers from foam templates
Open Access
- 20 November 2013
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 16 (4) , 1931-1940
Abstract
Mechanical frothing can be used to create gas–liquid monomer foams, which can then be subsequently polymerised to produce macroporous polymers. Until recently, this technique was limited to producing low porosity macroporous polymers with poor pore morphology and compression properties. In this study, we show that high porosity (75–80%) biobased macroporous polymers with excellent mechanical compression properties (E = 163 MPa, σ = 4.9 MPa) can be produced by curing of epoxy resin foams made by mechanical frothing. The key to this is to utilise the very viscous nature and very short working time of a biobased epoxy resin. It was found that increasing the frothing time of the biobased epoxy resin reduces the pore diameter of the resulting macroporous polymers. These macroporous polymers were also found to be partially interconnected. The compression properties of the macroporous polymers with smaller average pore diameter were found to be higher than those of foams with larger pore diameters. Unlike emulsion templating, which uses high internal phase emulsions to produce macroporous polymers, called polyHIPEs, the mechanical frothing technique has the advantage of creating macroporous polymers from monomers which cannot be easily emulsified.Keywords
This publication has 46 references indexed in Scilit:
- Ion-responsive alginate based macroporous injectable hydrogel scaffolds prepared by emulsion templatingJournal of Materials Chemistry B, 2013
- Elastic behavior of multi-scale, open-cell foamsComposites Part B: Engineering, 2013
- Comparison of ceramic honeycomb monolith and foam as Ni catalyst carrier for methane autothermal reformingCatalysis Today, 2010
- Effects of nucleating agents on the morphological, mechanical and thermal insulating properties of rigid polyurethane poamsMacromolecular Research, 2009
- New insights into the relationship between internal phase level of emulsion templates and gas–liquid permeability of interconnected macroporous polymersSoft Matter, 2009
- Effects of cell size on compression and bending strength of aluminum-foamed material by complex stirring in induction heatingJournal of Materials Processing Technology, 2009
- Thermosetting foam with a high bio‐based content from acrylated epoxidized soybean oil and carbon dioxideJournal of Applied Polymer Science, 2007
- Foaming of aliphatic polyester using chemical blowing agentJournal of Applied Polymer Science, 2001
- Study of the formation of the open-cellular morphology of poly(styrene/divinylbenzene) polyHIPE materials by cryo-SEMColloid and Polymer Science, 1996
- Relation between the network structure and dynamic mechanical properties of a typical amine‐cured epoxy polymerJournal of Polymer Science Part A-2: Polymer Physics, 1970