Contribution to Improvement of Fatigue Properties of Zr-4 Alloy: Gradient Nanostructured Surface Layer versus Compressive Residual Stress
Open Access
- 19 November 2021
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 11 (11) , 3125
Abstract
The gradient nanostructured (GNS) layer forms beneath the surface of Zr-4 samples by the surface mechanical grinding treatment (SMGT) process, which increases the fatigue strength apparently due to the synergistic effect of the gradient nanostructured layer and compressive residual stress. The SMGTed Zr-4 samples are subjected to annealing to remove residual stress (A-SMGT) and the individual effect of the GNS layer and compressive residual stress can be clarified. The results show that the gradient nanostructure in the surface is stable after annealing at 400 °C for 2 h but residual stress is apparently removed. Both SMGTed and A-SMGTed Zr-4 samples exhibit higher fatigue strength than that of coarse-grained (CG) Zr-4 alloy. The fatigue fracture of Zr-4 alloy indicates that the hard GNS surface layer hinders fatigue cracks from approaching the surface and leads to a lower fatigue striation space than that of CG Zr-4 samples. The offset fatigue strength of 106 cycles is taken for SMRT-ed, A-SMRT-ed, and CG Zr-4 samples and the results indicate clearly that the GNS surface layer is a key factor for the improvement of fatigue strength of the Zr-4 alloy with surface mechanical grinding treatment.Keywords
Funding Information
- National Natural Science Foundation of China (51671158, 51621063)
This publication has 34 references indexed in Scilit:
- On the Correlation Between Fatigue Striation Spacing and Crack Growth Rate: A Three-Dimensional (3-D) X-ray Synchrotron Tomography StudyMetallurgical and Materials Transactions A, 2011
- Revealing Extraordinary Intrinsic Tensile Plasticity in Gradient Nano-Grained CopperScience, 2011
- A model for the formation of fatigue striations and its relationship with small fatigue crack growth in an aluminum alloyInternational Journal of Fatigue, 2010
- A detailed study of the relationship between fatigue crack growth rate and striation spacing in a range of low alloy ferritic steelsEngineering Failure Analysis, 2010
- Strain softening in nanocrystalline or ultrafine-grained metals: A mechanistic explanationMaterials Science and Engineering: A, 2008
- A new constitutive equation for strain hardening and softening of fcc metals during severe plastic deformationActa Materialia, 2008
- Fatigue life improvement through surface nanostructuring of stainless steel by means of surface mechanical attrition treatmentScripta Materialia, 2006
- Cyclic softening mechanisms of Zircaloy-4Journal of Nuclear Materials, 2004
- Biaxial low cycle fatigue properties and dislocation substructures of zircaloy-4 under in-phase and out-of-phase loadingMaterials Science and Engineering: A, 2000
- Hydrothermal preparation of nanometer lithium nickel vanadium oxide powder at low temperatureMaterials Science and Engineering: B, 2000