POYCARBONAT UND LICHT
Authors:
- Günther KäumpfGKGünther Käumpf
- GüntherGÜGünther
- Dieter FreitagDFDieter Freitag
- Werner WittWWWerner Witt
- 1 December 1990
- journal article
- Published by Wiley in Die Angewandte Makromolekulare Chemie
- Vol. 183 (1) , 243-272
Abstract
Polycarbonate (PC) based on 4,4'‐dihydroxydiphenyl‐2,2‐propane has adchieved an outstanding market relevance due to its extraordinary physical and technical properties, especially due to the combination of excellent impact strength and high heat distortion temperature (HDT) combined with good optical and electrical properties.This very attractive balance of properties has led to a broad and still expanding use of PC in different optical application areas. Therefore it has reached a significant importance as a material for glasing (compact sheet and twin wall sheet) and also for optical lenses. For lenses the high refraction index of PC (n = 1,58) and its low density have shown as additional advantages. Recently PC was introduced as a base material for polymeric optical fibers (POF) in the market: Despite its inherently high optical loss (about 800 dB/km at λ = 820 nm) PC has proved as an attractive material because of its high refractive index (cheap cladding, narrow bending radii) and its good HDT (use at relatively high temperatures, e.g. near the engine of automobiles), so far the maximum fiber length will not exceed 30 m.During the last decade PC with extremely high flow and purity became the material of choice for music consumer industry (compact disk: CD) and for optical data storage technology. So far all the CDs were produced worldwide from PC (1988: 450 Mio CD, 1989 about 650 Mio CD). These special PC grades are used for WORM disks (write once read multiple) and EOD disks (erasable optical disks) with diameter up to 13 cm. These disks are still in the phase of market introduction. For disk diameters greater than 13 cm up to 30 cm experimental products with very low birefringence combined with increased stiffness are currently under development (e.g. blends of modified PC with modified SAN).The continuous improvement of the commercial PC grades and the new development of structurely modified PC and special blends based on PC will lead to a further increasing consumption of PC and to further expanding applications of PC especially in the optical market area.Keywords
This publication has 5 references indexed in Scilit:
- Polymer optical fibers and nonlinear optical device principlesAdvanced Materials, 1989
- New plastic optical fiber using polycarbonate core and fluorescence-doped fiber for high temperature useFiber and Integrated Optics, 1988
- Optical Anisotropy of Polycarbonates1988
- Struktur und Eigenschaften von Mehrphasenkunststoffen I. Verträglichkeit von Polymeren im festen ZustandDie Angewandte Makromolekulare Chemie, 1977
- Polymers containing the 3,3,3′,3′‐tetramethyl‐1,1′‐spirobiindane residueJournal of Polymer Science Part A: General Papers, 1965