Single and multilayered materials processing by argon ion beam etching: study of ion angle incidence and defect formation
Authors:
- 18 August 2015
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 25 (9)
Abstract
Ion beam etching (IBE) is a very promising technique in microelectronics because of its capability to etch small patterns with a high resolution and inert materials. In this study, the angular incidence of an argon ion beam on the etch rate and uniformity is discussed in the case of several materials often used in microelectronics. The capability of the IBE technique to etch multilayered stack samples with positive anisotropic profiles was demonstrated on TiNiAu, TiNiCuAu, BST and PZT. Two typical defects involved in IBE processing (fences and not etched pattern foots) due to shadow masking and redeposition effect, are explained and solutions are presented to avoid them. Deep IBE was performed on GaN with an etch depth as high as 10 μ m, using a 8 μ m thick SiO 2 mask. The etching of other mask materials, such as TiN, was investigated in order to improve the selectivity. Using a TiN mask, a selectivity to GaN as high as 5 is reported. Finally, the etch rate enhancement needed for deep etching was studied.Keywords
This publication has 35 references indexed in Scilit:
- Introduction to gas dischargesPlasma Sources Science and Technology, 2000
- Handbook of Advanced Plasma Processing Techniques2000
- Characteristics of chemically assisted ion beam etching of gallium nitrideApplied Physics Letters, 1994
- Chemically assisted ion beam etching of GaAs, Ti, and MoJournal of Vacuum Science & Technology A, 1983
- Technology and applications of broad-beam ion sources used in sputtering. Part II. ApplicationsJournal of Vacuum Science and Technology, 1982
- Technology and applications of broad-beam ion sources used in sputtering. Part I. Ion source technologyJournal of Vacuum Science and Technology, 1982
- Selective Reactive Ion Beam Etching of SiO2 over Polycrystalline SiJournal of the Electrochemical Society, 1982
- Investigation of plasma etching mechanisms using beams of reactive gas ionsJournal of Vacuum Science and Technology, 1981
- Ion−beam etchingJournal of Vacuum Science and Technology, 1975
- Theory of Sputtering. I. Sputtering Yield of Amorphous and Polycrystalline TargetsPhysical Review B, 1969