The Tension and Puncture Properties of HDPE Geomembrane under the Corrosion of Leachate
Open Access
- 17 September 2013
- Vol. 6 (9) , 4109-4121
Abstract
To investigate the gradual failure of high-density polyethylene (HDPE) geomembrane as a result of long-term corrosion, four dynamic corrosion tests were conducted at different temperatures and durations. By combining tension and puncture tests, we systematically studied the variation law of tension and puncture properties of the HDPE geomembrane under different corrosion conditions. Results showed that tension and puncture failure of the HDPE geomembrane was progressive, and tensile strength in the longitudinal grain direction was evidently better than that in the transverse direction. Punctures appeared shortly after puncture force reached the puncture strength. The tensile strength of geomembrane was in inversely proportional to the corrosion time, and the impact of corrosion was more obvious in the longitudinal direction than transverse direction. As corrosion time increased, puncture strength decreased and corresponding deformation increased. As with corrosion time, the increase of corrosion temperature induced the decrease of geomembrane tensile strength. Tensile and puncture strength were extremely sensitive to temperature. Overall, residual strength had a negative correlation with corrosion time or temperature. Elongation variation increased initially and then decreased with the increase in temperature. However, it did not show significant law with corrosion time. The reduction in puncture strength and the increase in puncture deformation had positive correlations with corrosion time or temperature. The geomembrane softened under corrosion condition. The conclusion may be applicable to the proper designing of the HDPE geomembrane in landfill barrier system.Keywords
This publication has 20 references indexed in Scilit:
- Gravel contacts and geomembrane strains for a GM/CCL composite linerGeotextiles and Geomembranes, 2008
- Geomembrane strains from coarse gravel and wrinkles in a GM/GCL composite linerGeotextiles and Geomembranes, 2008
- Effect of Progressive Failure on Measured Shear Strength of Geomembrane/GCL InterfaceJournal of Geotechnical and Geoenvironmental Engineering, 2008
- The influence of bentonite extrusion on shear strength of GCL/geomembrane interfaceGeotextiles and Geomembranes, 2008
- Shear strength parameters of compacted fly ash–HDPE geomembrane interfacesGeotextiles and Geomembranes, 2006
- Effect of temperature on shear strength of two geomembrane–geotextile interfacesGeotextiles and Geomembranes, 2005
- Shear Strength Parameters of Soil-Geosynthetic Interfaces Under Low Confining Pressure Using a Tilting TableGeosynthetics International, 2002
- Geomembrane–geotextile interface shear properties as determined by inclined board and direct shear box testsGeotextiles and Geomembranes, 2001
- Analysis of tension development in geomembranes placed on landfill slopesGeotextiles and Geomembranes, 1999
- Assessment of HDPE geomembrane performance in a municipal waste landfill double liner system after eight years of serviceGeotextiles and Geomembranes, 1997