A custom built lathe designed for in operando high-energy x-ray studies at industrially relevant cutting parameters
- 1 October 2019
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 90 (10) , 103901
Abstract
We present a custom built lathe designed for in operando high-energy x-ray scattering studies of the tool-chip and tool-workpiece contact zones during operation. The lathe operates at industrially relevant cutting parameters, i.e., at cutting speeds ≤400 m/min and feeds ≤0.3 mm/rev. By turning tests in carbon steel, performed at the high-energy material science beamline P07 at Petra III, DESY, Hamburg, we observe compressive strains in TiNbAlN and Al2O3/Ti(C, N) coatings on the tool flank face during machining. It is demonstrated that by the right choice of substrate and coating materials, diffraction patterns can be recorded and evaluated in operando, both from the tool-workpiece and tool-chip contacts, i.e., from the contact zones between the tool and the workpiece material on the tool flank and rake faces, respectively. We also observe that a worn tool results in higher temperature in the tool-chip contact zone compared to a new tool.Keywords
Funding Information
- Faculty Grant SFO-Mat-LiU (2009-00971)
- Vetenskapsrådet (2011-6505)
- VINNOVA (2016-05156)
- Bundesministerium für Forschung, Technologie und Raumfahrt (05K12CG1)
This publication has 33 references indexed in Scilit:
- Microstructure evolution during the isostructural decomposition of TiAlN—A combined in-situ small angle x-ray scattering and phase field studyJournal of Applied Physics, 2013
- Pressure and temperature effects on the decomposition of arc evaporated Ti0.6Al0.4N coatings in continuous turningSurface and Coatings Technology, 2012
- Significant elastic anisotropy in Ti1−xAlxN alloysApplied Physics Letters, 2010
- Pressure enhancement of the isostructural cubic decomposition in Ti1−xAlxNApplied Physics Letters, 2009
- The microstructure of the affected zone of a worn PCBN cutting tool characterised with SEM and TEMWear, 2009
- Thermal decomposition products in arc evaporated TiAlN/TiN multilayersApplied Physics Letters, 2008
- Finite element modelling of temperature distribution in the cutting zone in turning processes with differently coated toolsJournal of Materials Processing Technology, 2005
- 2D FEM estimate of tool wear in turning operationWear, 2005
- Tribology of tool–chip interface and tool wear mechanismsSurface and Coatings Technology, 2002
- Modelling the orthogonal machining process using coated cemented carbide cutting toolsJournal of Materials Processing Technology, 2001