Growth and characterization of TiAlN∕CrAlN superlattices prepared by reactive direct current magnetron sputtering
- 8 December 2008
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 27 (1) , 29-36
Abstract
TiAlN and CrAlN coatings were prepared using a reactive direct current magnetron sputtering system from TiAl and CrAl targets. Structural characterization of the coatings using x-ray diffraction (XRD) revealed the B1 NaCl structure of TiAlN and CrAlN coatings with a prominent reflection along the (111) plane. The XPS data confirmed the bonding structures of TiAlN and CrAlN single layer coatings. Subsequently, nanolayered multilayer coatings of TiAlN∕CrAlN were deposited on silicon and mild steel (MS) substrates at different modulation wavelengths (Λ) with a total thickness of approximately 1.0μm. The modulation wavelengths were calculated from the x-ray reflectivity data using modified Bragg’s law. TiAlN∕CrAlN multilayer coatings were textured along (111) for Λ<200Å and the XRD patterns showed the formation of superlattice structure for coatings deposited at Λ=102Å. The x-ray reflectivity data showed reflections of fifth and seventh orders for multilayer coatings deposited at Λ=102 and 138Å, respectively, indicating the formation of sharp interfaces between TiAlN and CrAlN layers. The cross-sectional scanning electron microscopy image of TiAlN∕CrAlN multilayer coatings indicated a noncolumnar and dense microstructure. A maximum hardness of 39GPa was observed for TiAlN∕CrAlN multilayer coatings deposited at Λ=93Å, which was higher than the rule-of-mixture value (30GPa) for TiAlN and CrAlN. Study of thermal stability of the coatings in air using micro-Raman spectroscopy indicated that the TiAlN∕CrAlN multilayer coatings were stable up to 900°C in air. TiAlN∕CrAlN multilayer coatings also exhibited improved corrosion resistance when compared to the MS substrate.Keywords
This publication has 40 references indexed in Scilit:
- Structural, mechanical, and tribological studies of Cr–Ti–Al–N coating with different chemical compositionsThin Solid Films, 2008
- Structure, hardness and thermal stability of nanolayered TiN/CrN multilayer coatingsVacuum, 2003
- Properties of (Ti,Cr,Al)N coatings with high Al content deposited by new plasma enhanced arc-cathodeSurface and Coatings Technology, 2003
- High-temperature oxidation resistance of Cr1−Al N thin films deposited by reactive magnetron sputteringSurface and Coatings Technology, 2003
- The influence of low concentrations of chromium and yttrium on the oxidation behaviour, residual stress and corrosion performance of TiAlN hard coatings on steel substratesVacuum, 1999
- Synthesis of pseudobinary Cr-Al-N films with B1 structure by rf-assisted magnetron sputtering methodSurface and Coatings Technology, 1998
- Microstructure and oxidation-resistance of Ti1 − x − y −zAlxCryYzN layers grown by combined steered-arc/unbalanced-magnetron-sputter depositionSurface and Coatings Technology, 1997
- High temperature oxidation of ion-plated CrN filmsJournal of Materials Research, 1994
- High-temperature oxidation of ion-plated TiN and TiAlN filmsJournal of Materials Research, 1993
- Titanium aluminum nitride films: A new alternative to TiN coatingsJournal of Vacuum Science & Technology A, 1986