Silicon Micromachined D-Band Diplexer Using Releasable Filling Structure Technique
Open Access
- 3 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 68 (8) , 3448-3460
Abstract
A D-band waveguide diplexer, implemented by silicon micromachining using releasable filling structure (RFS) technique to obtain high-precision geometries, is presented here for the first time. Prototype devices using this RFS technique are compared with devices using the conventional microfabrication process. The RFS technique allows etching large waveguide structures with nearly 90° sidewall angles for the 400-μm-tall waveguides. The diplexer consists of two direct-coupled cavity six-pole bandpass filters, with the lower and the upper band at 130-134 and 141-148.5 GHz, respectively. The measured insertion loss of the two bands is 1.2 and 0.8 dB, respectively, and the measured return loss is 20 and 18 dB, respectively, across 85% of the passbands. The worst case adjacent channel rejection is better than 59 dB. The unloaded quality factors of a single cavity resonator are estimated from the measurements to reach 1400. Furthermore, for the RFS-based micromachined diplexer, an excellent agreement between measured and simulated data was observed, with a center frequency shift of only 0.8% and a bandwidth deviation of only 8%. In contrast to that, for the conventionally micromachined diplexer of this high complexity, the filter poles are not well controllable, resulting in a large center frequency shift of 3.5%, a huge bandwidth expanding of over 60%, a poor return loss of 6 and 10 dB for the lower and the upper band, respectively, and an adjacent channel rejection of only 22 dB.Keywords
Funding Information
- European Research Council (ERC) through the European Union’s Horizon 2020 Research and Innovation Program (616846)
- Swedish Foundation for Strategic Research Synergy Grant Electronics SE13-007
- European Union’s Horizon 2020 Research and Innovation Programme (644039 (M3TERA))
This publication has 47 references indexed in Scilit:
- Wireless sub-THz communication system with high data rateNature Photonics, 2013
- Silicon Micromachined Canonical ${\hbox{E}}$-Plane and ${\hbox{H}}$-Plane Bandpass Filters at the Terahertz BandIEEE Microwave and Wireless Components Letters, 2013
- G-band rectangular waveguide filter fabricated using deep reactive ion etching and bonding processesMicro & Nano Letters, 2012
- High aspect ratio silicon etch: A reviewJournal of Applied Physics, 2010
- A systematic study of DRIE process for high aspect ratio microstructuringVacuum, 2010
- Tolerance analysis for comb-drive actuator using DRIE fabricationSensors and Actuators A: Physical, 2006
- Geometrical pattern effect on silicon deep etching by an inductively coupled plasma systemJournal of Micromechanics and Microengineering, 2004
- Space Mapping: The State of the ArtIEEE Transactions on Microwave Theory and Techniques, 2004
- Effect of process parameters on the surface morphology and mechanical performance of silicon structures after deep reactive ion etching (DRIE)Journal of Microelectromechanical Systems, 2002
- Anisotropic silicon trenches 300–500 μm deep employing time multiplexed deep etching (TMDE)Sensors and Actuators A: Physical, 2001