Fracture Characteristics of AISI D2 Tool Steel at Different Tempering Temperatures Using Acoustic Emission and Fuzzy C-Means Clustering
Authors:
- 2 March 2013
- journal article
- research article
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 38 (8) , 2205-2217
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Effect of martensite phase volume fraction on acoustic emission signals using wavelet packet analysis during tensile loading of dual phase steelsMaterials & Design (1980-2015), 2010
- Comparison of wear properties of tool steels AISI D2 and O1 with the same hardnessTribology International, 2006
- Sintering behaviour and fracture toughness characterization of D2 matrix tool steel, comparison with wrought and PM D2Scripta Materialia, 2002
- Acoustic Emission Behavior during Tensile Tests of Low Carbon Steel Welds.ISIJ International, 1999
- Acoustic emission from tensile deformation of unnotched and notched specimens of AISI type 304 stainless steelsMaterials Science and Engineering: A, 1998
- Frequency spectrum analysis of acoustic emission signal obtained during tensile deformation and fracture of an AISI 316 type stainless steelActa Metallurgica, 1989
- NEURAL NETWORKS, PRINCIPAL COMPONENTS, AND SUBSPACESInternational Journal of Neural Systems, 1989
- Principal Component Analysis1986
- Frequency analysis of the signals generated by the failure of constituent wires of wire ropeNDT International, 1985
- Pattern Recognition with Fuzzy Objective Function Algorithms1981