Low Cycle Fatigue Properties of Sc-Modified AA2519-T62 Extrusion
Open Access
Abstract
This investigation presents the results of research on low cycle fatigue properties of Sc-modified AA2519-T62 extrusion. The basic mechanical properties of the investigated alloy have been established in the tensile test. The low cycle fatigue testing has been performed on five different levels of total strain amplitude: 0.4%; 0.5%; 0.6%; 0.7% and 0.8% with cycle asymmetry coefficient R = 0.1. For each level of total strain amplitude, the graphs of variations in stress amplitude and plastic strain amplitude in the number of cycles have been presented. The obtained results allowed to establish Ramberg-Osgood and Manson-Coffin-Basquin relationships. The established values of the cyclic strength coefficient and cyclic strain hardening exponent equal to k’ = 1518.1 MPa and n’ = 0.1702. Based on the Manscon-Coffin-Basquin equation, the values of the following parameters have been established: the fatigue strength coefficient σ’f = 1489.8 MPa, the fatigue strength exponent b = −0.157, the fatigue ductility coefficient ε’f = 0.4931 and the fatigue ductility exponent c = −1.01. The fatigue surfaces of samples tested on 0.4%, 0.6% and 0.8% of total strain amplitude have been subjected to scanning electron microscopy observations. The scanning electron microscopy observations of the fatigue surfaces revealed the presence of cracks in striations in the surrounding area with a high concentration of precipitates. It has been observed that larger Al2Cu precipitates exhibit a higher tendency to fracture than smaller precipitates having a higher concentration of scandium and zirconium.Keywords
Funding Information
- Polish Ministry of National Defence (PBG/13-998)
This publication has 39 references indexed in Scilit:
- Formation of precipitates and recrystallization resistance in Al–Sc–Zr alloysTransactions of Nonferrous Metals Society of China, 2012
- Fatigue crack growth in the D16CzATW aluminium alloy in the presence of a calibrated hole under simple bendingInternational Journal of Fatigue, 2012
- Fatigue crack growth in AlCu4Mg1 under nonproportional bending-with-torsion loadingMaterials Science, 2011
- Effects of Sc content on the mechanical properties of Al‐Sc alloysRare Metals, 2010
- Hydrostatic extrusion of UFG aluminiumInternational Journal of Material Forming, 2009
- A Study on Fatigue Properties of Sc Added Al 2519 AlloyKey Engineering Materials, 2005
- The effect of grain size on low-cycle fatigue behavior of Al-2024 polycrystalline alloyMetallurgical and Materials Transactions A, 2004
- Aluminium Alloys for Automotive ApplicationMaterials Science Forum, 1997
- Alloying aluminum alloys with scandium and zirconium additivesMetal Science and Heat Treatment, 1996
- Application of modern aluminum alloys to aircraftProgress in Aerospace Sciences, 1996