Multitemporal UAV Photogrammetry For Sandbank Morphological Change Analysis: Evaluations of Camera Calibration Methods, Co-Registration Strategies, and the Reconstructed DSMs
Authors:
Open Access
- 19 July 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 15 (19391404) , 5924-5942
Abstract
Sandbank morphology is a longshore corridor with fast morphological changes. To analyze its changes, unmanned aerial vehicle (UAV) is the preferred effective and flexible data collection platform, which can collect very high resolution images. UAV campaigns along corridor areas require well-distributed ground control points (GCP) and accurate geotagged image positions to avoid misalignment errors of generated digital surface models (DSMs). However, a sandy terrain can make the measurement of GCPs difficult or even impossible. Furthermore, UAVs are often equipped with consumer-grade devices (onboard GNSS and nonmetric cameras), which, therefore, cannot provide accurate image positions and lead to geometric distortions of the image network due to inappropriate lens distortion corrections. This article proposes a strategy to calibrate the used camera and co-register multitemporal images without the need for accurate geotagged information on the whole datasets and well-distributed GCPs. The proposed strategy includes two improvements. First, we performed semi-on-the-job self-calibration (semi-OTJSC) using UAV images with favor orientations and flight altitudes to precalibrate interior orientation parameters (IOPs) and additional lens distortion parameters. This was then followed by another OTJSC of IOPs involving images with accurate geotagged positions. Second, a “transferred aerial-triangulation (Trans-AT)” strategy is proposed to co-register two consecutive UAV datasets through AT procedure similar to GNSS-supported AT within a strip image block. The experimental results revealed that the proposed method provides the best-fit camera parameters and generates high-accuracy co-registered DSMs. This strategy contributes significantly to multitemporal camera calibration and co-registration procedures for determining morphological changes in corridor mapping.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST 107-2621-M-006-001, MOST 109-2116-M-017-001, MOST 108-2221-E-006-086, MOST 108-2623-E-006-003-D)
This publication has 58 references indexed in Scilit:
- Stability Analysis for a Multi-Camera Photogrammetric SystemSensors, 2014
- Mitigating systematic error in topographic models derived from UAV and ground‐based image networksEarth Surface Processes and Landforms, 2014
- Using Unmanned Aerial Vehicles (UAV) for High-Resolution Reconstruction of Topography: The Structure from Motion Approach on Coastal EnvironmentsRemote Sensing, 2013
- Sparse Iterative Closest PointComputer Graphics Forum, 2013
- A Semi-Automatic Image-Based Close Range 3D Modeling Pipeline Using a Multi-Camera ConfigurationSensors, 2012
- Beach erosion and recovery during consecutive storms at a steep‐sloping, meso‐tidal beachEarth Surface Processes and Landforms, 2011
- A convergent image configuration for DEM extraction that minimises the systematic effects caused by an inaccurate lens modelThe Photogrammetric Record, 2008
- A method for automated registration of unorganised point cloudsISPRS Journal of Photogrammetry and Remote Sensing, 2008
- Modelling the hydrodynamics of offshore sandbanksContinental Shelf Research, 2007
- A method for registration of 3-D shapesIEEE Transactions on Pattern Analysis and Machine Intelligence, 1992