A Battery-Less BLE IoT Motion Detector Supplied by 2.45-GHz Wireless Power Transfer
- 1 July 2018
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 68-75
Abstract
Wireless power transfer (WPT) is a possible way to achieve cheap, rapid and large-scale deployment of battery-less IoT smart sensors. However, the key challenge in designing WPT-supplied smart sensors is to ensure that the harvested power is higher than the consumed power in presence of strong WPT path loss. This paper presents the design and optimization of a smart sensor supplied by 2.45-GHz RF power and performing infrared-based motion detection and Bluetooth Low Energy (BLE) communication. The full system (RF energy harvester, power management, sensor transducer and interface, control, data processing and wireless transmission) is implemented using low-power off-the-shelf components. In the sensing sub-system, low average power is achieved using efficient duty-cycling of the analog front-end. In the harvesting sub-system, architecture choice and design of the matching network and rectifier circuit allow to optimize the total power harvesting efficiency (PHE). The implemented smart sensor can operate reliably with an incident RF power as low as -10.9 dBm. The sensing sub-system exhibits an average power of 4.3 μW and a maximum number of transmitted event packets of 60 packets per hour.Keywords
This publication has 7 references indexed in Scilit:
- Review on supercapacitors: Technologies and materialsRenewable and Sustainable Energy Reviews, 2016
- Can we connect trillions of IoT sensors in a sustainable way? A technology/circuit perspective (Invited)2015
- A 0.48mm2 5μW-10mW indoor/outdoor PV energy-harvesting management unit in a 65nm SoC based on a single bidirectional multi-gain/multi-mode switched-cap converter with supercap storage2015
- Co-Design of a CMOS Rectifier and Small Loop Antenna for Highly Sensitive RF Energy HarvestersIEEE Journal of Solid-State Circuits, 2014
- An RF-to-DC energy harvester for co-integration in a low-power 2.4 GHz transceiver frontend2012
- A 90-nm CMOS Threshold-Compensated RF Energy HarvesterIEEE Journal of Solid-State Circuits, 2011
- Low-Power CMOS Rectifier Design for RFID ApplicationsIEEE Transactions on Circuits and Systems I: Regular Papers, 2007