A convenient, reliable, and fast acoustic pressure field measurement method for magnetic resonance-guided high-intensity focused ultrasound systems with phased array transducers
Open Access
- 2 July 2018
- journal article
- research article
- Published by Springer Nature in Journal of Therapeutic Ultrasound
- Vol. 6 (1) , 5
Abstract
With the expanding applications of magnetic resonance-guided high-intensity focused ultrasound (MR-HIFU), there is an urgent need for a convenient, reliable, and fast acoustic pressure field measurement method to aid treatment protocol design, ensure consistent and safe operation of the transducer, and facilitate regulatory approval of new techniques. Herein, we report a method for acoustic pressure field characterization of MR-HIFU systems with multi-element phased array transducers. This method integrates fiber-optic hydrophone measurements and electronic steering of the ultrasound beam with MRI-assisted HIFU focus alignment to the fiber tip. A clinical MR-HIFU system (Sonalleve V2, Profound Medical Inc., Mississauga, Canada) was used to assess the proposed method. A fiber-optic hydrophone was submerged in a degassed water bath, and the fiber tip location was traced using MRI. Subsequently, the nominal transducer focal point indicated on the MR-HIFU therapy planning software was positioned at the fiber tip, and the HIFU focus was electronically steered around the fiber tip within a 3D volume for 3D pressure field mapping, eliminating the need for an additional, expensive, and MRI-compatible 3D positioning stage. The peak positive and negative pressures were measured at the focus and validated using a standard hydrophone measurement setup outside the MRI magnet room. We found that the initial MRI-assisted HIFU focus alignment had an average offset of 2.23 ± 1.33 mm from the fiber tip as identified by the 3D pressure field mapping. MRI guidance and electronic beam steering allowed 3D focus localization within ~ 1 h, i.e., faster than the typical time required using the standard laboratory setup (~ 3–4 h). Acoustic pressures measured using the proposed method were not significantly different from those obtained with the standard laboratory hydrophone measurements. In conclusion, our method offers a convenient, reliable, and fast acoustic pressure field characterization tool for MR-HIFU systems with phased array transducers.Keywords
Funding Information
- Foundation of Barnes Jewish Hospital (0000)
This publication has 17 references indexed in Scilit:
- Boiling histotripsy lesion characterization on a clinical magnetic resonance imaging-guided high intensity focused ultrasound systemPLOS ONE, 2017
- A review of numerical and experimental compensation techniques for skull-induced phase aberrations in transcranial focused ultrasoundInternational Journal of Hyperthermia, 2013
- Characterization of a multi-element clinical HIFU system using acoustic holography and nonlinear modelingIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2013
- MR-guided focused ultrasound surgery, present and futureMedical Physics, 2013
- Investigation of Standing-Wave Formation in a Human Skull for a Clinical Prototype of a Large-Aperture, Transcranial MR-Guided Focused Ultrasound (MRgFUS) Phased Array: An Experimental and Simulation StudyIEEE Transactions on Biomedical Engineering, 2011
- Measurement of high intensity focused ultrasound fields by a fiber optic probe hydrophoneThe Journal of the Acoustical Society of America, 2006
- A polyvinylidene fluoride needle hydrophone for ultrasonic applicationsUltrasonics, 1985
- Piezoelectric polymer probe for ultrasonic applicationsThe Journal of the Acoustical Society of America, 1981
- Fiber-optic hydrophoneThe Journal of the Acoustical Society of America, 1977
- Calibration of ultrasonic beams for bio-medical applicationsPhysics in Medicine & Biology, 1970