A novel optical accelerometer
Authors:
- 1 May 1995
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 16 (5) , 166-168
Abstract
A novel accelerometer based on a PIN photo-detector and a micro-machined cantilever-beam-supported optical shutter with seismic mass has been designed, fabricated, and tested. Anisotropic wet etching of orientation silicon in KOH is used to fabricate an optical shutter consisting of evenly spaced vertically etched slots. The shutter, which also constitutes the seismic mass of the accelerometer, is suspended by two cantilever beams. The special structure of the device and the high aspect ratio of the cantilever beams (7.5) permit freedom of the movement for the proof mass (the shutter) on the /spl plusmn/X axis only. The actual size of the device is 3/spl times/4 mm and its amplified output varies linearly from -3.6 V to +3.6 V for accelerations from -84 g to +84 g. The measured resonant frequency of the device is 3.2 KHz. A dual diode structure is chosen for the photo-detector to compensate for temperature drift and the amplified output voltage changes by less than 40 mV for a temperature variation from 25/spl deg/C to 50/spl deg/C.Keywords
This publication has 4 references indexed in Scilit:
- A novel electromagnetic accelerometerIEEE Electron Device Letters, 1994
- Precision accelerometers with μg resolutionSensors and Actuators A: Physical, 1990
- A review of low cost accelerometers for vehicle dynamicsSensors and Actuators A: Physical, 1990
- Vertical Etching of Silicon at very High Aspect RatiosAnnual Review of Materials Science, 1979