Experimental Investigation of Different Hydrous Ethanol-Gasoline Blends on a Flex-Fuel Engine
- 6 October 2010
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In Brazilian market, Flex-Fuel vehicles represented over 90% of new light-duty vehicles sold in 2009. These vehicles can use gasoline blended with anhydrous ethanol (20 to 25% v/v), 100% of hydrous ethanol (contains from 6,2 to 7,4% w/w of water) or any blend of these fuels. An experimental investigation was done to study fuel consumption, emissions and in-cylinder pressure data of a Flex-Fuel Otto engine, 1.4 L, 4 cylinders. It used gasoline with 22% of anhydrous ethanol as a reference fuel (E22). E22 was blended with different hydrous ethanol contents such as 50% (H50) and 80% (H80), also a 100% hydrous ethanol H100) was used. The main fuel properties were analyzed as part of this work. To control the engine operation, a programmable ECU (Engine Control Unit) was used, allowing spark timing calibration either for maximum break torque (MBT) or to keep the engine below the knocking limit. Operating conditions included partial load with stoichiometric air-fuel ratio, and high load with rich mixture for four different engine speed conditions. In-cylinder pressure data was analyzed by using a special data acquisition system and a piezoelectric pressure sensor installed on the spark plug. Some combustion characteristics, such as combustion duration, indicated mean effective pressure (IMEP) and others were calculated based on in-cylinder pressure curve data. Test results were handled by the STATISTICA® software that calculated different regression curves for each output variable, based on torque, speed and ethanol content.Keywords
This publication has 9 references indexed in Scilit:
- Measurement Methodologies for Hydrocarbons, Ethanol and Aldehyde Emissions from Ethanol Fuelled VehiclesSAE International Journal of Fuels and Lubricants, 2010
- Fuel Consumption Technical and Economical Study for Flexible Fuel VehiclesSAE International Journal of Advances and Current Practices in Mobility, 2009
- In Cylinder Pressure Curve Simulation On Multifuel Engines - A Comparison Between A Polytrophic And General Thermodynamic Model For Gasoline, Ethanol And Natural GasSAE International Journal of Advances and Current Practices in Mobility, 2007
- SPARK IGNITION ENGINE PERFORMANCE USING SEVERAL ALCOHOL CONCENTRATIONS IN GASOLINE AND CNGSAE International Journal of Advances and Current Practices in Mobility, 2005
- RATING THE PERFORMANCE OF BRAZILIAN FLEX FUEL VEHICLESSAE International Journal of Advances and Current Practices in Mobility, 2005
- Experimental Analyses of Flexible Fuel Systems in Spark Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 2005
- Internal Combustion Engine Handbook Basics, Components, Systems, and Perspectives2004
- Experimental Investigation of SI Engine Performance Using Oxygenated Fuel2002
- Development and Use of a Cycle Simulation to Predict SI Engine Efficiency and NOx EmissionsSAE International Journal of Advances and Current Practices in Mobility, 1979