2‐Hydroxyethylmethacrylate carrying uniform porous particles: preparation and electron microscopy
- 10 December 2001
- journal article
- research article
- Published by Wiley in Polymer International
- Vol. 51 (1) , 75-84
Abstract
Uniform macroporous particles carrying hydroxyl groups have been obtained in the size range 3–11.5 µm by seeded polymerization. For this purpose, uniform polystyrene particles in the size range 1.9–6.2 µm were used as seeds. The seed particles were successively swollen by dibutyl phthalate (DBP) and a monomer mixture comprising styrene, 2‐hydroxyethylmethacrylate (HEMA) and a crosslinker. Two different crosslinkers, divinylbenzene (DVB) and ethylene glycol dimethacrylate (EGDMA), were tested. Size distribution properties together with bulk and surface structures of the particles have been characterized by both scanning and transmission electron microscopy. While EGDMA provides uniform particles with a non‐porous surface, DVB produces uniform particles having a highly porous surface and interior. The comparison of FTIR and FTIR‐DRS spectra shows that the HEMA concentration is higher on the particle surface than within the particle interior. Seed latex size and monomer/seed latex ratios are identified as the most important variables affecting the final particles. Different seed latexes have been tried; the result is that highly macroporous particles with a sponge‐like pore structure both on the surface and in the particle interior have been obtained by use of the seed latex with the largest particles and the lowest molecular weight. An increase in the HEMA feed concentration leads to final particles with a non‐porous surface and a crater‐like porosity in the particle interior. The average pore size significantly decreases with increasing DBP/seed latex and monomer/seed latex ratios.© 2001 Society of Chemical IndustryKeywords
This publication has 39 references indexed in Scilit:
- Amino-containing cationic latex–oligodeoxyribonucleotide conjugates: application to diagnostic test sensitivity enhancementColloids and Surfaces A: Physicochemical and Engineering Aspects, 1999
- Cibacron blue F3G-A-attached uniform and macroporous poly(styrene-co-divinylbenzene) particles for specific albumin adsorptionJournal of Biomaterials Science, Polymer Edition, 1999
- Application of porous microspheres prepared by SPG (Shirasu porous glass) emulsification as immobilizing carriers of glucoamylase (GluA)Journal of Applied Polymer Science, 1997
- New Designs of Macroporous Polymers and Supports: From Separation to BiocatalysisScience, 1996
- Phagocytosis of monosize polystyrene-based microspheres having different size and surface propertiesJournal of Biomaterials Science, Polymer Edition, 1996
- Fine control of the porous structure and chromatographic properties of monodisperse macroporous poly(styrene‐co‐divinylbenzene) beads prepared using polymer porogensJournal of Polymer Science Part A: Polymer Chemistry, 1994
- Studies of water‐soluble oligomers formed in emulsion copolymerizationJournal of Applied Polymer Science, 1994
- Solution and emulsion polymerization with partially neutralized methacrylic acidJournal of Applied Polymer Science, 1991
- Polymerization behavior and distribution of carboxyl groups in preparation of soap-free carboxylated polystyrene latexesJournal of Applied Polymer Science, 1977
- Preparation and characterization of soap-free carboxylated polystyrene latexesJournal of Applied Polymer Science, 1976