Numerical Study of Heat Transfer Intensification in a Circular Tube Using a Thin, Radiation-Absorbing Insert. Part 2: Thermal Performance
Open Access
Abstract
This article is the second part of the work under the same title, which is based on the results of the research presented in the previous article: “Numerical study of heat transfer intensification in a circular tube using a thin, radiation-absorbing insert. Part 1: Thermo-hydraulic characteristics”. Part 1 presents an analysis of pressure drops and heat transfer intensification in a round tube with an insert, using the phenomenon of radiation absorption. In this paper, an analysis of the tested insert’s thermal performance (PEC) is presented, taking into account the criterion of equal pumping power. The tests were carried out for the range of Re = 5000–100,000 numbers, for various insert diameters (from 20% to 90% of the pipe diameter) and a constant temperature difference between the wall and the gas ∆T = 100 °C. The highest Nu numbers were observed for inserts with dimensionless diameters of 0.3 and 0.4, while the highest flow resistance was observed for inserts with diameters of 0.6 and 0.7 of the channel diameter. The thermal efficiency was calculated in two ways, as was the associated Nu number. These results significantly differed from each other: the maximum PEC values for method (I) reached 2, and for method (II) to 8. The common feature for both calculation methods was the fact that the maximum values of the Nu number and the thermal efficiency were observed for small Re numbers; however, as the Re number increases, PEC and Nu number decrease strongly.Keywords
This publication has 27 references indexed in Scilit:
- A review study on twisted tape inserts on turbulent flow heat exchangers: The overall enhancement ratio criteriaInternational Communications in Heat and Mass Transfer, 2014
- Numerical study of the thermo-hydraulic characteristics in a circular tube with ball turbulators. Part 1: PIV experiments and a pressure dropInternational Journal of Heat and Mass Transfer, 2014
- Numerical study of the thermo-hydraulic characteristics in a circular tube with ball turbulators. Part 2: Heat transferInternational Journal of Heat and Mass Transfer, 2014
- Numerical investigation of conventional and modified Savonius wind turbinesRenewable Energy, 2013
- Convection and radiation heat transfer in a tube with core rod and honeycomb network inserts at high temperatureJournal of Mechanical Science and Technology, 2013
- Numerical Study of Friction Factor and Heat Transfer Characteristics for Single-Phase Turbulent Flow in Tubes with Helical Micro-FinsArchive of Mechanical Engineering, 2012
- Heat transfer enhancement in a tube with twisted tape inserts placed separately from the tube wallExperimental Thermal and Fluid Science, 2012
- Numerical Analysis of Flame Behavior Near the Quenching Conditions During Passage from Wider to Narrower Tube DiametersCombustion Science and Technology, 2012
- Heat transfer enhancement in a tube using circular cross sectional rings separated from wallApplied Energy, 2008
- Enhancement of heat transfer using porous convection-to-radiation converter for laminar flow in a circular ductInternational Journal of Heat and Mass Transfer, 1996