Effect of Boron Carbide Filler on the Curing and Mechanical Properties of an Epoxy Resin
- 15 May 2009
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 85 (4-5) , 216-238
Abstract
The curing process, wear behavior, and mechanical properties of an epoxy adhesive filled with boron carbide (B4C) were studied. Two different particle sizes and amount of reinforcing B4C were tested. One advantage of using B4C is its ability to absorb neutrons, a property of great importance in the nuclear industry. Gel time and degree of curing were measured to evaluate the effect of adding B4C to the epoxy resin. The chemical structure was studied by Fourier Transform Infrared Spectroscopy (FTIR) and the B4C distribution was analyzed by laser confocal microscopy. Dynamic Mechanical Thermal Analysis (DMTA) tests were also carried out to monitor the viscoelastic properties and the glass transition temperature (Tg) of the cured reinforced epoxy. The wear resistance against alumina was measured using a pin-on-disc test, evaluated as mass loss. The wear tracks were studied by Scanning Electron Microscopy (SEM). The bending strength was also studied to assess the degree of interaction between the B4C and the matrix. The results showed that the reinforced epoxy with B4C was very abrasive, wearing the alumina. The reinforced epoxy had excellent mechanical properties that increased with B4C content and with small particles. Moreover, the Tg value decreased slightly upon B4C addition.Keywords
This publication has 27 references indexed in Scilit:
- Effect of Silane Treatment on SiC Particles Used as Reinforcement in Epoxy ResinsThe Journal of Adhesion, 2009
- Neutron shielding material based on colemanite and epoxy resinRadiation Protection Dosimetry, 2005
- Pressureless Sintering of Boron CarbideJournal of the American Ceramic Society, 2003
- Influence of the reactivity of amine hydrogens and the evaporation of monomers on the cure kinetics of epoxy-amine: kinetic questionsPolymer, 1997
- A Study of Reaction Kinetics by Near-Infrared Spectroscopy. 2. Comparison with Dielectric Spectroscopy of Model and Multifunctional Epoxy/Amine SystemsMacromolecules, 1995
- Glass transition temperature as a function of conversion in thermosetting polymersMacromolecules, 1991
- A New Derivation of Post Gel Properties of Network PolymersMacromolecules, 1976
- Differential scanning calorimetry of epoxy cure: isothermal cure kineticsThermochimica Acta, 1976
- Calorimetric investigation of polymerization reactions. III. Curing reaction of epoxides with aminesJournal of Polymer Science Part A-1: Polymer Chemistry, 1970
- Gamma Rays from Short-Lived Fission-Fragment IsomersPhysical Review B, 1966