Study of Etch Rate and Surface Roughness in Chemical Etching of Stainless Steel
Author:
- 6 December 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 364-366, 837-842
Abstract
In this study, stainless steel material (X5CrNi1810) was micromachined by chemical etching method. Ferric chloride was selected as etchant which is the most widely used etchant for iron-based materials. Four different etchant concentrations (32 °Bé, 36 °Bé, 40 °Bé and 44 °Bé) were used at various etching temperature. Moreover, the influence of the addition of hydrochloric acid to main etchant on etching performance was examined. The aim of this study was to investigate the depth of etch and surface roughness affected by etchant concentration, hydrochloric acid addition and etching temperature. It was observed that etching temperature for any etchant concentration is important factor in case of depth of etch and surface roughness. It was also noticed that the addition of hydrochloric acid to main etchant increased depth of etch value at any etching temperature. The optimum etching parameters were obtained for the chemical etching of stainless steel.Keywords
This publication has 5 references indexed in Scilit:
- Characterisation of aqueous ferric chloride etchants used in industrial photochemical machiningJournal of Materials Processing Technology, 2004
- A new etchant for the chemical machining of St304Journal of Materials Processing Technology, 2004
- Microfabrication by electrochemical metal removalIBM Journal of Research and Development, 1998
- Electrochemical micromachining: An environmentally friendly, high speed processing technologyElectrochimica Acta, 1997
- Surface Textures of Annealed AISI 304 Stainless Steel Etched by Aqueous Ferric Chloride—Hydrochloric Acid SolutionsTransactions of the IMF, 1981