Effect of Cryogenic Cooling of Tool Electrode on Machining Titanium Alloy (Ti–6Al–4V) during EDM
Authors:
- 11 March 2015
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 31 (4) , 475-482
Abstract
The discharge characteristics and discharge gap of machining Ti–6Al–4V titanium alloy by cryogenically cooled tool electrode electrical discharge machining (EDM) in distilled water were investigated in this study using the monopulse discharge method. The influence of the cryogenically cooled tool electrode on the discharge gap and the initial maintaining voltage between the electrode and workpiece were analyzed under various temperatures. Test results showed the initial maintaining voltage of the cryogenically cooled tool electrode EDM was lower than that of conventional EDM. The discharge gap of the cryogenically cooled tool electrode EDM was also smaller than that of conventional EDM, which improved the copying accuracy of die-sinking EDM. A comparative experiment of machining Ti–6Al–4V titanium alloy was carried out by using cryogenically cooled tool electrode EDM and conventional EDM, lower electrode wear, higher material removal ratio, and higher corner size machining accuracy was obtained by using cryogenically cooled tool electrode EDM.Keywords
Funding Information
- Fund of Aeronautics Science (2013ZE52069)
- Foundation for Young Scientists (NS2014046)
This publication has 10 references indexed in Scilit:
- Performance Evaluation of Electrical Discharge Machining (EDM) Process Using Cryogenically Cooled ElectrodeMaterials and Manufacturing Processes, 2012
- Effect of Deep Cryogenic Treatment on Machinability of Titanium Alloy (Ti-6246) in Electric Discharge DrillingMaterials and Manufacturing Processes, 2010
- Cooling Effect on Electrode and Process Parameters in EDMMaterials and Manufacturing Processes, 2010
- Reducing electrode wear ratio using cryogenic cooling during electrical discharge machiningThe International Journal of Advanced Manufacturing Technology, 2009
- Effects of the cryogenic cooling on the fatigue strength of the AISI 304 stainless steel ground componentsCryogenics, 2006
- Titanium and Titanium Alloys2003
- Titanium alloys and their machinability—a reviewJournal of Materials Processing Technology, 1997
- Quantification of surface damage of tool steels after EDMInternational Journal of Machine Tools and Manufacture, 1988
- Plasma channel growth and the resolidified layer in edmPrecision Engineering, 1986
- Heat conduction model for the calculation of the volume of molten metal in electric dischargesJournal of Physics D: Applied Physics, 1974