Effect of Temperature and Thermal Shock on Concrete Containing Hazardous Electronic Waste
- 1 April 2018
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Hazardous, Toxic, and Radioactive Waste
- Vol. 22 (2)
Abstract
This paper presents an experimental investigation of the effect of temperature and thermal shock on the physical and mechanical properties of concrete (M25) incorporating electronic waste (E-waste). The concrete mixtures were prepared using 10, 20, 30, 40, 50% of E-waste plastic [high impact polystyrene (HIPS)] as a partial replacement per unit volume of coarse aggregate. The compressive strength, ultrasonic pulse velocity, and surface hardness of concrete specimens were examined before and after the thermal exposure. The concrete cube specimens with HIPS were heated to 100, 200, and 300°C for 1 h using muffle furnace. The compressive strength of specimens at room temperature was decreased with an increase of HIPS content. However, the specimens retained the compressive strength of about 50 at 50% HIPS replacement. Similarly, the compressive strength of specimens subjected to elevated temperatures after thermal shock decreased with an increase of HIPS and temperature. The nondestructive tests were carried out using a rebound hammer and ultrasonic pulse velocity test. The rebound hammer results provides very consistent results similar to experimental values. Regardless the temperature, concrete incorporated upto 25% HIPS showed an ultrasonic pulse velocity within the limiting value . This study shows the feasiblility of using E-waste plastic (HIPS) in concrete as construction material in order to reduce the environmental pollution and conserve the natural resource from depletion.
Keywords
This publication has 21 references indexed in Scilit:
- Properties of Modified Asphalt Binders Blended with Electronic Waste PowdersJournal of Materials in Civil Engineering, 2012
- Use of plastic waste as aggregate in cement mortar and concrete preparation: A reviewConstruction and Building Materials, 2012
- Waste printed circuit boards nonmetallic powder as admixture in cement mortarMaterials and Structures, 2012
- Evaluation of PET waste aggregates in polymer mortarsConstruction and Building Materials, 2012
- Recycling of PET bottles as fine aggregate in concreteWaste Management, 2010
- Material and structural performance evaluation of recycled PET fiber reinforced concreteCement and Concrete Composites, 2010
- Use of recycled plastic in concrete: A reviewWaste Management, 2008
- Degradation of recycled PET fibers in Portland cement-based materialsCement and Concrete Research, 2005
- Effects of waste PET bottles aggregate on the properties of concreteCement and Concrete Research, 2005
- Use of post-consumer waste plastics in cement-based compositesCement and Concrete Research, 1996